Somogyi Elektronic NKLL 06 Magnifying LED Desk Lamp Instruction Manual
- June 13, 2024
- SOMOGYI ELEKTRONIC
Table of Contents
Somogyi Elektronic NKLL 06 Magnifying LED Desk Lamp Instruction Manual
Product Instruction
Before using the product for the first time, please read the instructions for use below and retain them for later reference. The original instructions were written in the Hungarian language. This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given instruction concerning use of the appliance and they have understood the hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user maintenance on the appliance under supervision.
- SMD LED light sources exclusive plastic luminaire
- head part is adjustable among wide range
- 290 mm glass magnifying lens
- magnification: 3 diopters
- secondary lens: 12 diopters lift-up protective cover soft rubber feet
PARTS OF THE LAMP (Figure 1.)
- lamp base
- toggle switch
- lamp shaft
- adjustable head part
- glass magnifying lens
- protective lid
- power cable
APPLICATION
This magnifying LED desk lamp is ideal to use in such cases, when enlarging of details is indispensable, e.g.: for soldering circuits, mode-building, etc. It is energy saving, the consumption is minimal, while its brightness is 400 lumens. Color-temperature is cold (6500 K), so the illumination is more detailed.
INSTALLATION
- Carefully remove the packaging, taking care not to damage the luminaire.
- After unpacking, set the lamp on a stable and horizontal surface.
- Set the target position by moving the shaft and the head part as desired. Warning! Do not stare directly to the light of LED!
- Only power on the lamp after this has been done.
- You can switch on (1) or off (0) the lamp with the toggle switch.
REPLACING THE MAGNIFYING LENS
Warning! Power off the luminaire by unplugging it from the electric outlet before replacing the lens! Allow the luminaire to cool down. The lens should only be replaced by a specialist!
- Unscrew the 7 crews from the transparent lid
- Gently turn the transparent lid to get access to the lens.
- Carefully remove the glass lens, if it has broken, the cracked lens may cause injury!
- Put the new lens to its place.
- Put back the transparent lid by tightening its screws
CLEANING
Warning! Power off the luminaire by unplugging it from the electric outlet before cleaning the luminaire! Allow the luminaire to cool down! The luminaire and the magnifying lens may require cleaning at least once a month, depending on the manner of use and degree of contamination. Use a soft, dry cloth to remove any stubbom deposits from the luminaire. The glass magnifying lens can be deaned using non-abrasive glass cleaners. Do not apply the cleaning fluid directly to the lens, use a soft cloth instead to do so.
WARNINGS
- Confirm that the appliance has not been damaged in transit.
- Only for indoor use, in a dry place!
- Use only if it is placed on a stable, horizontal surface!
- Never use in wet, humid places!
- Protect the unit from direct sunlight or other thermal radiation!
- Fragile! Handle with care, the cracked lens may cause injury!
- Power supply cannot be different from the required (230 V~/50 Hz)!
- Product contains LED light sources, which are forbidden to replace with any other light sources, eg. bulbs!
- LED light source in the luminaire is not replaceable!
- It is not dimmable!
- Do not stare into the light of LED! Do not direct the light of LED towards other persons or to reflecting surfaces!
- When the LEDs are switched on, do not scan mirror-like objects or others with glossy surface!
- Slight warming up of the head part is natural. Do not cover the lamp!
- The appliance should be located so as to allow easy access and removal of the power plug!
- Lead the power cable so as to prevent it from being pulled out accidentally or tripped over!
- Never touch the luminaire and the power cable with wet hands!
- In case of any damage or malfunction, immediately power off the lamp and contact a specialist!
- When not planning to use the unit for an extended period of time, remove power plug from the outlet!
Caution: Risk of electric shock! Do not attempt to disassemble or modify the unit or its accessories. In case any part is damaged, immediately power off the unit and seek the assistance of a specialist.
In the event that the power cable should become damaged, it should only be replaced by the manufacturer, its service facility or similarly qualified personnel.
SPECIFICATION
rated voltage:. 220-240 V, 50/60 Hz
output:…. .6W
shock protection class: …… II.
operating temperature range: -10-+40 °C (=+40°C
dimensions: .140 x 350 x 240 mm
weight: 0,85 kg
magnifying lens diameter/magnification/secondary lens: 290 mm/x3/x12
IP protection: …. … IP20: Not protected from ingress of water
light source: 30 pcs SMD 5630 LED cold white (6500K) 400 Lumens
brightness
Waste equipment must not be collected separately or disposed of with household waste because it may contain components hazardous to the environment or health. Used or waste equipment may be dropped off free of charge at the point of sale, or at any distributor which sells equipment of identical nature and function. Dispose of product at a facility specializing in the collection of electronic waste. By doing so, you will protect the environment as well as the health of others and yourself, If you have any questions, contact the local waste management organization, We shall undertake the tasks pertinent to the manufacturer as prescribed in the relevant regulations and shall bear any associated costs arising.
Producer/Gyártó/Výrobca/Producător/Proizvođač/Výrobce/Proizvođač/Producent
SOMOGYI ELEKTRONIC Kft. H-9027 Győr, Gesztenyefa út 3.
www.somogyi.hu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>