ROUGH COUNTRY 99071 Rubber Molle Panel Clamp Kit Instructions
- June 13, 2024
- Rough Country
Table of Contents
ROUGH COUNTRY 99071 Rubber Molle Panel Clamp Kit
Product Information
- Product Name: Rubber Molle Panel Clamp Kit
- Compatibility: Universal
- Package Contents: 2 Clamps
- SKU: 99071
- Tools Needed: 4mm Allen Wrench
- Torque Specs: Hand Tighten
Product Usage Instructions
- Start by installing clip nuts onto the backing plates. Ensure that the threaded stud on the clip nut is facing the same direction as the tab of the backing plate. Refer to Photo 1.
- Using the provided hardware, place washers on the 6mm x 30mm bolts and insert them through the clamp and then through the Molle panel in your desired mounting location. Refer to Photo 2.
- Insert the bolt through the flat side of the clip nut. Make sure that the threaded stud on the clip nut and the tab on the backing plate are facing away from the Molle panel. See Photo 3.
- Tighten the bolts using a 4mm Allen wrench. Avoid over-tightening. Refer to Photo 4.
Note: Hand-tighten the bolts according to the torque specs mentioned in the product manual.
Thank you for choosing Rough Country for all your vehicle needs.
Please read the instructions before beginning installation. Check the kit
hardware against the kit contents shown below. Be sure you have all the needed
parts and know where they go. If a question exists, please call us at
@1-800-222-7023. We will be happy to
answer any questions concerning this product. Check all fasteners for proper
torque. Check to ensure adequate clearance between all components.
Periodically check all hardware for tightness.
- SKU: 99071
- Tools Needed: 4mm Allen Wrench
- Torque Specs: Hand Tighten
INSTALLATION INSTRUCTIONS
- Install clip nuts onto backing plates. Be sure the threaded stud on the clip nut is facing the same direction as the tab of the backing plate. See Photo 1.
- Using the provided hardware, add washers to the 6mm x 30mm bolts and insert through the clamp and then through the molle panel in the desired mounting location. See photo 2.
- Insert bolt through the flat side of the clip nut. Be sure the threaded stud on the clip nut and tab on the backing plate is facing away from the molle panel. See Photo 3.
- Tighten bolts using a 4mm Allen wrench. Do not over-tighten. See Photo 4.
By purchasing any item sold by Rough Country, LLC, the buyer expressly warrants that he/she is in compliance with all applicable, State, and Local laws and regulations regarding the purchase, ownership, and use of the item. It shall be the buyer’s responsibility to comply with all Federal, State, and Local laws governing the sales of any items listed, illustrated, or sold. The buyer expressly agrees to indemnify and hold harmless Rough Country, LLC for all claims resulting directly or indirectly from the purchase, ownership, or use of the items.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>