ANCHOR TM35 Tilting Flat Panel TV Mount User Guide

June 13, 2024
ANCHOR

ANCHOR TM35 Tilting Flat Panel TV Mount

ANCHOR TM35 Tilting Flat Panel TV Mount

Warnings

  • The wall mounted parts of the TV mount must be firmly attached to a concrete/brick/solid wood wall, or wall studs behind drywall.
  • Tighten screws so that the wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws and increase the chances of failure.
  • Do not remove or loosen any screws until they are no longer engaged with the mount. Doing so may cause the screen to fall.
  • It is recommended to have this mount professionally installed.
  • WARNING : This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov. This product meets and complies with all Federal regulations.

Parts

ANCHOR TM35 Tilting Flat Panel TV Mount 1

Tools
The following tools are recommended for this installation:

  • Drill
  • 5/32” or 4mm drill bit for drywall
  • 3/8” or 10mm drill bit for concrete
  • Stud finder
  • Phillips screwdriver
  • Tape measure

Dimensions & Weights

  • 840 x 520 x 62mm / 33 x 20.5 x 2.44”
  • Supports VESA up to 800 x 500mm.
  • This mount is designed to hold a maximum of 132 lbs (60 kg).
  • For TV size 37”-80”

Step 1A: Concrete Wall Mounting

ANCHOR TM35 Tilting Flat Panel TV Mount 2

Step 1B: Drywall with Wooden Stud Mounting

ANCHOR TM35 Tilting Flat Panel TV Mount 3

Only drill into wooden studs behind drywall. Use a stud finder to locate studs if needed. DO NOT DRILL AND HANG THE BASE PLATE ON DRYWALL OR SHEETROCK WITHOUT STUDS. It is not strong enough to support a TV and will cause damage.

Step 2A: Attach Bracket to TV

ANCHOR TM35 Tilting Flat Panel TV Mount 4

Step 2B: Attach Bracket to TV with Curved Back or Obstruction

ANCHOR TM35 Tilting Flat Panel TV Mount 5

Attach the two brackets to the rear of your television, making sure the claw of the bracket is in the upper position and the tightening screw is in the lower position.
Use the included screws and washers to secure the bracket to your TV. Find the set that fits your TV and discard the rest.

Step 3: Hang the TV on the Wall Mount

ANCHOR TM35 Tilting Flat Panel TV Mount 6 Customer Support

Customer Service: 1-888-999-4215
Email Support: prodinfo@dpiinc.com
Email Parts: partsinfo@dpiinc.com

For Warranty Information and the most up-to-date version of this User’s Guide, go to www.gpx.com
To download this User’s Guide in English, Spanish, or French, or to get answers to frequently asked questions, visit the support section at: www.gpx.com
Copyright © 2019 Digital Products International (DPI, Inc.) All other trademarks appearing herein are the property of their respective owners. Specifications are subject to change without notice.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals