ANCHOR BEACON BEA-7500 Sound System Instruction Manual

ANCHOR BEACON BEA-7500 Sound System

REQUIREMENTS

• 8,000 or series 2 Go Getter unit with I/O board at revision E (or newer)
• Screw drivers (Phillips #1 and #2)
• 8 mm Nutdriver

INSTRUCTIONS

1. Make sure the unit is powered off and the plug is disconnected.
2. Remove the screws around the back panel.
3. Remove the back panel.
4. Remove the battery harness.
5. Remove the low and high and speaker harness.
   • If applicable please remove the mic receiver harness.
6. Remove the old Bluetooth module.
7. Remove the old harness from the Bluetooth module and use the included harnesses with the new Bluetooth module.
8. Connect the black and white audio cables to BT Audio
9. Connect the red and black cables to BT only
10. Reinstall the back panel to the unit and tighten with screws.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>