TORRAS WX-M153-01 PloyPow 3 In 1 Wireless Charger Instruction Manual

SAFETY MANUAL
In order to bring you a better experience, please read this safety manual carefully before using this
product and keep it properly for future reference.

Specifications

Charging Cable xl, Charger xl (Optional), Quick Guide x1, Safety Manual x1

The parameters above are derived from the laboratory of TORRAS. The actual parameters would be different due to production process and other factors. The image shown here is indicative only.

Important Safety Instructions

1. This product is only suitable for Apple Phone 12 and above, Apple Watch, Air Pods, not for charging other brand products.
2. Please make sure your phone supports wireless charging, otherwise it will not be able to charge.
3. Please don’t put metal/magnet/credit card on your phone or phone case, otherwise it will affect the wireless charging or even can’t charge.
4. This wireless charger is not compatible with non-Mag Safe cases such as Otter box Defender cases. Do not use a case that is more than 2mm thick or it will not charge.
5. Do not disassemble, hit, crush or throw it into fire. Incorrect reassembly may result in fire or make a risk of injury.
6. Do not use this product under severe high temperature, humidity or corrosive conditions to avoid damaging the circuitry with leakage.
7. Do not spill water or other liquids on the wireless charger. If you need to clean it, please make sure the power is disconnected.
8. When charging, please keep the distance between the implanted medical device (pacemaker, cochlear implant, etc.) and the wireless charger at least 20cm to avoid potential interference with the medical device.
9. When using a charger for power supply, please purchase or use a charger that has obtained certification and meets the standard requirements. Make sure to use a charging adapter that has a single-port output of 30W or greater.
10. Use of power cords or chargers other than those recommended or sold by the manufacturer of this product can result in a risk of fire or personal injury.
11. Do not use a charger with an output of 5V **** 1A (5W) or less.
12. High temperatures will reduce charging speed and also limit power, a problem that occurs with all wireless chargers. It is recommended to charge your device at room temperature.
13. The position of the phone case and device on the wireless charger will affect the charging speed. The further away from the center of the wireless charger, the slower the charging speed is.
14. When charging, it may get hot. It is a normal phenomenon, no need to worry.
15. Improper use, dropping or excessive force may cause damage to this product.
16. Do not use harmful chemicals or detergents to clean this product.
17. Please store this product in a cool and dry place, do not store this product in a hot or humid environment.
18. Keep this product out of the children.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/ TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

FCC Warning

15.19 Labeling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause  undesired operation.
15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC RF Radiation Exposure Statement:

1. This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
2. This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with minimum distance 15cm between the radiator and your body.

LANHE GROUP CO., LTD.
SHENZHEN TORRAS TECHNOLOGY CO., LTD.
Address: RM1215, BLK C, Zhantao Technology BLDG, Minzhi Avenue, Minzhi ST, Longhua
DIST, Shenzhen, China
© Shenzhen TORRAS Technology Co., Ltd. All Rights Reserved.
Email: support@torraslife.com Made in China

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>