torras X002P2141B Dashboard and Windshield Car Mount Holder User Manual

torras X002P2141B Dashboard and Windshield Car Mount Holder

Dear customer,
Thank you for purchasing our product. Please read the following instructions carefully before first use and keep this user manual for future reference. Pay particular attention to the safety instructions. If you have any questions or comments about the device, please contact the customer line.

• www.alza.co.uk/kontakt
• +44 (0)203 514 4411
• Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz.

Specifications

• Product name: Car Phone Mount
• Applicable places: Air Vent, Dashboard, Windshield, Tables and so on
• Package list:
  • Car Phone Mount x 1
  • Air Vent Clip x 1
  • Suction Cup x 1
  • Dashboard Pad x 1
  • User Guide x 1

The parameters above are derived from the laboratory of TORRAS. The actual parameters would be different because of products and other factors. The image shown here is indicative only.

Product overview

Installation steps

Method 1 – Using with the Suction Cup

Tips for using the Suction Cup

1. It will do not stick tightly when sticky the suction cup on the curved surface, plush cloth surface or uneven surface.
2. It is not recommended to attach the suction cup to leathers, walls or film-coated glass surfaces since the suction cup is designed with strong stickiness which may cause surface damaged.
3. The suction would become weaker if the suction cup is frequently used at high or low temperatures or in humid conditions. (Please avoid exposing it to the sun directly.)
4. Please take down the suction cup base and wash it with warn water if the suction of the cup is not strong enough after a period use. It will be sticky again after drying naturally.
5. Please ensure the suction cup is covered by plastic wrap when the suction cup holder was removed.

Tips for placing the Dashboard Pad
Before installing the mount on uneven or textured dashboard, please firstly stick the gel pad on the dashboard (use only once). Tear off the red protective sticker of the pad, stick it on the dashboard and press it firmly for over 30 seconds then let it rest for 1-3 days to reach high strong stickiness.

Warm Tip:
Please wait for 24 hours to use after sticking the dashboard pad.

Car Mount assemble steps

1. Unscrew the retaining nut from the car mount and remove it.
2. Insert the ball joint into the retaining nut from the smaller side.
3. Push the ball joint firmly into the groove on the back of the car mount, then tighten the retaining nut.
4. Clean the windshield or dashboard where you want to install the car mount with a wet cloth, wait for it to dry.
5. If the installation position is not smooth enough, it is recommended to use the dashboard pad in advance. Then install the suction cup on the pad, it would be more stable. (If no need to use dashboard pad, please go to step 6 directly.)
6. Push the suction cup lock up to be full open.
7. Tear off the transparent protective film of the suction cup. Then attach the suction cup to the cleaning dashboard and press down the suction cup lock to secure the car mount.
8. Find the best view by adjusting the length and angle of the car mount to adapt to the driving environment.

Method 2 – Using with the Twist-lock Air Vent Clip

1. Unscrew the retaining nut from the car mount and remove it.
2. Insert the ball joint into the retaining nut from the smaller side.
3. Push the ball joint firmly into the groove on the back of the car mount, then tighten the retaining nut.
4. Twist the screw knob to adjust the opening size of the clip to fit the air vent.
5. Find a suitable place to insert the car mount. Tighten the screw knob to fix the car mount. Adjust the angle of the car mount to fit your sight.

The suitability of car air vent
The air vent clip could be compatible with horizontal and vertical air vent outlets. But it cannot support non-intensive, circular, or special-shaped air vent outlets.

Note:
Please do not twist the air vent clip too tight, to protect the air vent blade and air vent clip.

Using steps

1. Press the release button, the clamp arms will automatically pop open.
2. Put the phone in and press the sides of the clamp arms to clamp tightly to ensure the mobile phone fixed in securely.
3. After use, press the release button again to open the clamp arms and take out the mobile phone as shown in the picture.

Attentions

1. Avoid dropping.
2. Do not disassemble.
3. Please install the car mount on a suitable place before driving, do not operate or adjust the car mount during driving.
4. Do not install the car mount in places where it might interfere with airbag or driving.
5. Keep the car mount away from children.

Warranty Conditions

A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you need repair or other services during the warranty period, contact the product seller directly, you must provide the original proof of purchase with the date of purchase.

The following are considered to be a conflict with the warranty conditions, for which the claimed claim may not be recognized:

• Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation, and service of the product.

• Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g., during transport, cleaning by inappropriate means, etc.).

• Natural wear and aging of consumables or components during use (such as batteries, etc.).

• Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.

• If anyone has made modifications, modifications, alterations to the design or adaptation to change or extend the functions of the product compared to the purchased design or use of non-original components.

• www.alza.co.uk/kontakt

• +44 (0)203 514 4411

• Importer Alza.cz a.s., Jankovcova 1522/53, Holešovice, 170 00 Praha 7, www.alza.cz.

References

• Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
• Alza.sk – rýchly a pohodlný nákup odkiaľkoľvek | alza.sk
• Alza | Alza.co.uk
• Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
• Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
• Alza.cz
• alza.de
• alza.hu
• alza.sk

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>