NightRider NWSLM-DPM LEDS Wiring Harness Adapter Instruction Manual

**NightRider NWSLM-DPM LEDS Wiring Harness Adapter Instruction Manual

**

Replacing an Existing Light

When replacing an existing light check how the previous light is connected to the wiring.

• A: Previous light also used a female Deutsch plug connector: unplug old light and plug in the new one.
• B: Previous light used a large screw plug to connect with vehicle wiring: unplug old light and use an adapter piece (Part# NWSPL-DPM). Plug in your new light using the Deutsch plug connector.
• C: Previous light was hardwired into the vehicle’s wiring harness: Cut off the old light’s wiring and use one of the following two options:
  • a: Cut off the female Deutsch plug on the light side and hardwire the new light back into the vehicle’s wiring harness the same way as the previous light.
    b: Hardwire a male Deutsch plug connector to the existing wiring harness (Part# NWDP-M), then plug the new light into the newly added Deutsch connector. (This method allows for a quick and easy replacement of lights the next time around.)”
    **Part# NWSLM-DPM

Part# NWDP-M**

Installing a New Light

When installing a new light to your vehicle or piece of equipment, the following options are available:

1. Cut off the existing female Deutsch plug from the end of the light’s wire and then hardwire it into the vehicle’s wiring harness.
2. Hardwire a male Deutsch plug wire lead (NWDP-M) into your vehicle’s wiring harness, then plug in the new light.
3. Purchase an extra wiring harness (NWH1 – connects one light or NWH2 – connects two lights) and then plug your new light into the Deutsch connector(s) of the new wiring harness.
   **Part# NWH1

Part# NWH2
**

ECONOMY SERIES
www.nightriderleds.com

References

• NightRider LEDS | Automotive, Equipment, and Commercial LED Lighting – Light Up Your Life!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>