NightRider LEDS NWSB-8 Universal 8 Gang Switch Panel Instruction Manual
- June 12, 2024
- NightRider LEDS
Table of Contents
ightRider LEDS NWSB-8 Universal 8 Gang Switch Panel Instruction Manual
Control Box Installation
Mounting The Control Box
There are TWO different mounting options provided to mount the control box, including:
- Fix mount bracket
- Flush mount
The ideal mounting of the control box should allow for an unobstructed path for the power wires, accessory wires and the control harnesses included.
If you decide to drill, please check the clearance behind the drilling location. Make sure you are not going to drill through and damage any wiring harness and components of the vehicle.
Option 1: Fix Mount
Using the mounting bracket as a guide, find a good and desired location to
mount the control box.
Option 2: Flush Mount
Using the control box as a guide, find a good and desired location to mount.
Switch Panel Installation
Switch Panel Mounting
There are TWO different mounting options provided to mount the switch panel, including:
- Angle adjustable mount bracket
- Slim line flush mount bracket
Attach the switch panel to the mount bracket you need, then use the supplied screw accessories to fix the bracket.
The ideal thickness of the mounting surface should be between 1/8″ to 1/4″.
Check to make sure the control wire and extension plug&play wire is long enough to mount the desired location.
Check the clearance behind the drilling location. Make sure you are not going to drill through and damage any wires or components of the vehicle.
Once you decide where to mount, use the bracket to mark the drill location.
After the installation of the panel, proceed to the wiring installation.
Option 1: Angle Adjustable Mount
Option 2: Slim Line Flush Mount
Wire Connectins
Connect to 8 auxiliary LED lights or electrical devices
This switch panel control system has eight switch circuits, each has a maximum
current rating. The total operating amperage of the connected accessories can
not exceed 60 amps (600 watts). You may have multiple electrical devices or
auxiliary LED lights connected that total more than 60 amps, but you can not
have them turned on at the same time. Otherwise, the control box will be
damaged. The switch panel comes configured with the following fuses:
| Circuit 1 | Circuit 2 | Circuit 3 | Circuit 4 |
|---|---|---|---|
| 30A | 30A | 20A | 20A |
| Circuit 5 | Circuit 6 | Circuit 7 | Circuit 8 |
| 10A | 10A | 5A | 5A |
Switch Panel Indication
- Red LED lights up to show the circuit is on
- Area for DIY placement of the selected labels
- Green LED illumination area, back light for the label
- Manual power activation button, press to turn on/off Function momentary.
Backlit Brightness Adjustable
There are FIVE different levels of backlit brightness of this 8 gang switch
panel control system.
Connect the ‘White Wire’ to the Width/Position Lamp or ACC or Car Cigarette
Adaptor, then the backlit brightness can be adjusted in 100% or 80% or 60% or
40% or even 20% brightness
50 PCS Reusable Switch Lables
-
Thoroughly clean the switch panel. Use warm soapy water first to remove all wax and dirt. Then dry and use a cleaner such as rubbing alcohol to clean the surface. Once clean do not touch.
-
Peel off the label and firmly press down on the switch panel.
-
DIY labels included for your specific needs.
-
The best way to install and control many LED lights or any other electrical devices.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>