NightRider LEDS 300W Solar LED Flood Light Instruction Manual
- June 12, 2024
- NightRider LEDS
Table of Contents
NightRider LEDS 300W Solar LED Flood Light
This product is suitable for a wide range of locations and applications such as courtyards, storefronts, signage, boat docks, and more. No access to power is needed allowing use in remote locations. Solar panels and flood lights are separate units. Both units can thus be placed in their respective optimal location. Please note: The lamp lens as well as the solar panel are made from glass. Please handle this with care during transportation and storage. IP65 certified – weatherproof/rated for outside use
Remote Control Functions
- The solar panel is to be installed so that it will receive the optimal amount of direct sunlight.
- Make sure that trees or buildings will not block the sun from charging the solar panel. Please note: the panel cannot be installed under glass or indoors.
- If the lamp needs to be inspected, take the following steps:
- Place the solar panel and the lamp in a location with sufficient lighting and connect the light and panel via a cord.
- Cover the solar panel with an opaque material (simulating nighttime), this should then turn the lamp on. Please make sure that the solar panel has enough time to charge its batteries before covering it up to test the light.
Maintenance Instructions
- Clean glass lamp cover and solar panel regularly to allow optimal light transmission.
- Cleaning should be done with a soft dry rag. Do not use corrosive cleaning solutions or water.
- Do not disassemble this product without prior consent from its manufacturer.
- Do not use any charger to charge this product.
Storage
When not in use, this light should be stored in a place with good air
circulation and little dust. The ambient temperature should be between -10’C
and +40°C. Do not store in a very cold environment Keen this produce say from
corrosive substances In order to keep the battery in good working order, this
light needs to be charged and discharged once a month al Leasa Product
warranty is based on the correct preservation, installation, use, and
maintenance of this product. Villages caused by improper installation and
violation of product operation regulations are not
equally.
Product Specifications
Product Assembly
Installation: (wall or pole mount)
- Install the lamp using the included expansion screws (Figure 1). Make sure to keep the lamp and solar panels within the distance of the available cable length.
- As shown in Figure 2, install the solar panel on the wall and rotate the solar panel bracket to place the solar panel at the appropriate angle to the sun, The panel is to receive direct sunlight for as long as possible and should not be obstructed by buildings or trees.
- Correctly installing the solar panel will ensure the longest irradiation time and thus optimal charging. Please note that the solar panel is not to be installed under glass or indoors.)
- As shown in Figure 3, the lamp bracket can be installed at 280°. This lamp’s angle can easily be set according to the lighting needs of a specific location (see Figure 4)
- Once installation is completed, connect the power line of the lamp with the solar panel.
- Make sure to fully connect the joint to ensure that the connection will be waterproof.
- The cord of the flood light measures 50cm, and the one of the solar panels is 400cm.
Operation Instructions
Insert the battery into the remote control, then press the ‘ON’ button to turn the light on and the OFF’ button to turn the light off. You can also set different lighting modes with the help of the remote control, please see next page for instructions. After debugging or inspecting the lamp, it is necessary to press “Auto” on your remote control. This will reset the lamp’s control system to its normal working mode.
Please note: The lamp lens as well as the solar panel are made from glass. Please handle with care during transportation and storage.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>