NightRider LEDS NSL45 COMPACT SERIES Compact Light Instruction Manual
- June 12, 2024
- NightRider LEDS
Table of Contents
NightRider LEDS NSL45 COMPACT SERIES Compact Light
Wiring Up Your Compact Light
All NightRider™ Compact Lights are equipped with a female Deutsch plug.(
NSL45 and N912F only come with a pig tail wire lead)
Replacing an Existing Light
When replacing an existing light check how the previous light is connected to the wiring.
- Previous light also used a female Deutsch plug connector: unplug old light and plug in the new one.
- Previous light used a large screw plug to connect with vehicle wiring: unplug old light and use an adapter piece (Part# NWSPL-DPM). Plug in your new light using the Deutsch plug connector.
- Previous light was hardwired into the vehicle’s wiring harness: Cut off the old light’s wiring and use one of the following two options:
- Cut off the female Deutsch plug on the light side and hardwire the new light back into the vehicle’s wiring harness the same way as the previous light.
- Hardwire a male Deutsch plug connector to the existing wiring harness (Part# NWDP-M), then plug the new light into the newly added Deutsch connector. (This method allows for a quick and easy replacement of lights the next time around.)
Installing a New Light
When installing a new light to your vehicle or piece of equipment, the following options are available:
- Cut off the existing female Deutsch plug from the end of the light’s wire and then hardwire it into the vehicle’s wiring harness.
- Hardwire a male Deutsch plug wire lead (NWDP-M) into your vehicle’s wiring harness, then plug in the new light.
- Purchase an extra wiring harness (NWH1 – connects one light or NWH2 – connects two lights) and then plug your new light into the Deutsch connector(s) of the new wiring harness.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>