NightRider LEDS NWDP-M 5 Inch Square 45W Flood Heavy Duty Lights Instructions
- June 13, 2024
- NightRider LEDS
Table of Contents
NightRider LEDS NWDP-M 5 Inch Square 45W Flood Heavy Duty Lights Instructions
1. Replacing an Existing Light
When replacing an existing light check how the previous light is connected to the wiring.
A: Previous light also used a female Deutsch plug connector: unplug old light
and plug in the new one.
B: Previous light used a large screw plug to connect with vehicle wiring:
unplug old light and use an adapter piece (Part# NWSPL-DPM). Plug in your new
light using the Deutsch plug connector.
C: Previous light was hardwired into the vehicle’s wiring harness: Cut off the
old light’s wiring and use one of the following two options:
a: Cut off the female Deutsch plug on the light side and hardwire the new
light back into the vehicle’s wiring harness the same way as the previous
light.
b: Hardwire a male Deutsch plug connector to the existing wiring harness
(Part# NWDP-M), then plug the new light into the newly added Deutsch
connector. (This method allows for a quick and easy replacement of lights the
next time around.)
2. Installing a New Light
When installing a new light to your piece of equipment, the following options are available:
- Cut off the existing female Deutsch plug from the end of the light’s wire and then hardwire it into the vehicle’s wiring harness.
- Hardwire a male Deutsch plug wire lead (NWDP-M) into your vehicle’s wiring harness, then plug in the new light.
- Purchase an extra wiring harness (NWH1 – connects one light or NWH2 – connects two lights) and then plug your new light into the Deutsch connector(s) of the new wiring harness.
HEAVY DUTY
www.nightriderleds.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>