sygonix SY-5801968 Solar outdoor wall light Neutral White Anthracite Gray Instruction Manual

sygonix SY-5801968 Solar outdoor wall light Neutral White Anthracite Gray

Specifications

• Akku: 3,7 V, 2000 mAh, 7,4 Wh, Lithium-Ionen
• Solarmodul: Monokristallin 4,86 V 1,5 W
• Ladedauer des Akkus: ca. 7 Std. (bei optimalen Bedingungen)
• Betriebsdauer des Akkus:
• Schwellenwerte des Lichtsensors: EIN: < 20 Lux / AUS: > 120 Lux
• Bewegungssensor (PIR): Erfassungsbereich: max. 5 m
• Schutzart: IP54
• Helligkeit: max. 1000 lm
• Schutzklasse: III
• Abmessungen (B x H x T): 284 x 62 x 50 mm
• Gewicht: 312 g

Product Usage Instructions

Safety Instructions
Read the operating instructions carefully and especially observe the safety information. Failure to follow the safety instructions may result in personal injury or damage to property.

Installation
Ensure the product is mounted securely on a wall using the provided mounting bracket, screws, and dowels.

Operation

• Make sure the ambient light has decreased and the motion sensor is active for the product to function.
• Press the mode button to cycle through the different lighting modes: A, B, C, D.

Adjusting Light Modes

• Mode A: One blink
• Mode B: Two blinks
• Mode C: Three blinks
• Mode D: Four blinks

Troubleshooting

Problem: The light does not turn on.
Solution: Ensure the battery is charged. Place the product in a dark area away from other light sources. Select an appropriate mode.

Cleaning and Maintenance
Regularly clean the solar panels to maximize charging efficiency using a lint-free cloth.

Disposal
Dispose of the product at designated collection points in Conrad stores or authorized recycling centres.

Intended use

• The product is an LED lamp with motion sensor and light sensor. There are four lighting modes, and the battery is recharged by the integrated solar panel.
• The product has an IP54 ingress protection rating. It is resistant against dust and water splashing from all directions. Do not submerge.
• If you use the product for purposes other than those described, the product may be dam-aged.
• Improper use can result in short circuits, fires, or other hazards.
• The product complies with the statutory national and European requirements.
• For safety and approval purposes, you must not rebuild and/or modify the product.
• Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions.
• All company names and product names are trademarks of their respective owners. All rights reserved.

Delivery contents

• Product with wall bracket
• 2x Mounting screws
• 2x Dowels
• Operating instructions

Operating Instructions for download

Use the link www.conrad.com/downloads (alternatively scan the QR code) to download the complete operating instructions (or new/current versions if available). Follow the instructions on the web page.

Description of symbols

The following symbols are on the product/appliance or are used in the text:

• The symbol warns of hazards that can lead to personal injury.
• The symbol warns of dangerous voltage that can lead to personal injury by electric shock.
• This product is constructed according to protection class III.

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.

General

• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
• If you have questions that remain unanswered by this information product, contact our technical support service or other technical personnel.
• Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.

Handling
Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.

Operating environment

• Do not place the product under any mechanical stress.
• Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.

Operation

• Consult an expert when in doubt about the operation, safety or connection of the product.
• If it is no longer possible to operate the product safely, take it out of operation and pro-tect it from any accidental use. DO NOT attempt to repair the product yourself. The safe operation can no longer be guaranteed if the product:
  • is visibly damaged,
  • is no longer working properly,
  • has been stored for extended periods in poor ambient conditions or
  • has been subjected to any serious transport-related stresses.

Li-ion battery

• The rechargeable battery is permanently built into the product and cannot be replaced.
• Never damage the rechargeable battery. Damaging the casing of the rechargeable battery might cause an explosion or a fire!
• Never short-circuit the contacts of the rechargeable battery. Do not throw the battery or the product into fire. There is a danger of fire and explosion!
• Charge the rechargeable battery regularly, even if you do are not using the product. Due to the rechargeable battery technology being used, you do not need to discharge the rechargeable battery first.

LED light

• Do not look directly into the LED light!
• Do not look into the beam directly or with optical instruments!

Installation

• When penetrating the surface e.g. drilling or inserting fasteners, make sure no cables or pipes are damaged.
• Inadvertently penetrating electric cables causes the life-threatening danger of an electric shock!

Product Overview

1. Solar panel
2. PIR sensor / indicator
3. Mode button
4. Body
5. Mounting bracket 6 Light panel

Choosing a location

Find a location that exposes the solar module to full sunlight to allow the rechargeable battery to recharge during the day.

Consider the following:

• The solar panel should be exposed to maximum sunlight. Do not set up the product in the shade or under any cover.
• Avoid the direct proximity of other light sources such as yards or streetlights, otherwise, the product will not switch on automatically at nightfall.

Wall mount

When penetrating the surface e.g. drilling or inserting fasteners, make sure no cables or pipes are damaged. Inadvertently penetrating electric cables causes the life-threatening danger of an electric shock!

1. Use the mounting plate as a template to mark holes on the surface.
2. Drill holes on the marked positions.
3. Attach the product using the supplied dowels and screws.

Make sure the product is securely mounted before letting go.

Recharge batteries

Important:
To maximize charging efficiency, keep the solar panel(s) clean and free from debris.

• Solar charge the battery under bright sunlight for at least 8 hours:
  • Before first use
  • After prolonged periods without exposure to sunlight e.g. rain.

Operation

Note:
There is an integrated light sensor that responds to ambient light levels. The product will be active when ambient light falls below a set level (nighttime). The product will deactivate when the ambient light rises above a set level (daytime).

Setting light modes
Preconditions:

• Ambient light levels have dropped, and the motion sensor is active.
• The battery is charged.

1. Press and hold the mode button to switch the power ON/OFF.
2. Press the mode button repeatedly to cycle through modes.
3. The different modes are as follows:

Notes:

• The indicator is relatively dim and may not be visible in bright conditions.
• If the rechargeable battery is getting low, the max. brightness levels may be lowered to prolong battery life.

Motion detection
For best motion detection

• The subject should move across the sensor.
• The sensor should not be placed behind glass.

Note:
The sensor should be mounted at a maximum height of 2.5 – 3 meters.

• Detection range: max. 5 m
• Detection angle: 120°

Troubleshooting

Cleaning and care

Important:

• Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
• Do not immerse the product in water.

1. Keeping the solar panels clean will maximize charging efficiency.
2. Clean the product with a fibre-free cloth.

Disposal
This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.

Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste. Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of. It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.

Technical data

This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited. This publication reflects the technical status at the time of printing.
Copyright by Conrad Electronic SE.
*2900984_V2_0224_dh_mh_en 9007200392493451-2 I2/O2 en

FAQ

Q: Can the battery be replaced?
A: No, the battery is built-in and cannot be replaced.

Q: What is the maximum detection range of the motion sensor?
A: The motion sensor has a maximum range of 5 meters.

References

• Conrad Electronic » All parts of success
• Download center

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>