FORD 415-00C Information and Entertainment System Instruction Manual

June 4, 2024
Ford

415-00C Information and Entertainment System
General Information – Vehicles With
SYNC 3

Removal and Installation

Front Controls Interface Module (FCIM)
Special Tool(s)

General Equipment

Interior Trim Remover
Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. NOTE: If installing a new module, it is necessary to upload the module configuration information to the scan tool prior to removing the module. This information must be downloaded into the new module after installation.
    Using a diagnostic scan tool, begin the PMI process for the FCIM following the on-screen instructions.

  2. Open the floor console arm rest.FORD 415 00C Information and Entertainment System - FIG 1

  3. Release the clips and remove the floor console trim panel.
    Disconnect the electrical connector.
    Use the General Equipment: Interior Trim RemoverFORD 415 00C Information and
Entertainment System - FIG 2

  4. Release the clips and remove the RH floor console upper trim panel.
    Use the General Equipment: Interior Trim RemoverFORD 415 00C Information and
Entertainment System - FIG 3

  5. Release the clips and remove the LH floor console upper trim panel.
    Use the General Equipment: Interior Trim RemoverFORD 415 00C Information and
Entertainment System - FIG 4

  6. Open the media bin.FORD 415 00C Information and Entertainment System - FIG 5

  7. Remove the media hub.
    Disconnect the electrical connectors.
    Use the General Equipment: Interior Trim RemoverFORD 415 00C Information and
Entertainment System - FIG 6

  8. NOTE: On both sides.
    Position the floor console’s upper side trim panel aside.FORD 415 00C
Information and Entertainment System - FIG 7.

  9. Remove the bolts, release the clips and remove the media bin assembly.
    Disconnect the electrical connectors.
    Torque: 22 lb.in (2.5 Nm)FORD 415 00C Information and Entertainment System -
FIG 8

  10. Release the clips and remove the instrument panel speaker grille.
    Disconnect the electrical connector.
    Use the General Equipment: Interior Trim RemoverFORD 415 00C Information and
Entertainment System - FIG 9

  11. 1. Remove the bolts.
    Torque: 22 lb.in (2.5 Nm)
    2. Remove the screws.
    Torque: 11 lb.in (1.2 Nm)
    3. Disconnect the electrical connectors and remove the FCIM.FORD 415 00C
Information and Entertainment System - FIG 10

Installation

  1. To install, reverse the removal procedure.
  2. NOTE: This step is only necessary if replacing the component.
    Using a diagnostic scan tool, complete the PMI process for the FCIM following the on-screen instructions.

© Copyright 2022, Ford Motor Company.
https://www.fordtechservice.
dealerconnection.com
2016 MKX
Procedure revision date:
12/19/2017

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals