Saddle Tramp BC-HDVL-HD2 Lower Fairing Vent Light Instruction Manual
- June 10, 2024
- Saddle Tramp
Table of Contents
BC-HDVL-HD2 Lower Fairing vent light
INSTALLATION INSTRUCTIONS
**2014+ Lower vent fairing LED w/signal indicator**
BC-HDVL-HD2 Lower Fairing Vent Light
-
Remove outer fairing For detailed instructions use BC-HDR-K1
-
Locate the left and right signals, and install t-harness inline.
-
From the rear of the lower fairing remove the (2) bolts, lift off grille from outer rim towards the motorcycle using non-marring pry tools.
NOTE: Bolts are different lengths,
place back into same location removed from.
-
Route all wires from upper fairing, clearing any pinch points or triple tree locks on the brake and clutch sides with supplied wire management hardware.
-
Line up mounting tabs of the new lighted grille, and snap insert into place. Reinstall mounting bolts into on backside of lower fairing.
-
Connect lower vent lights, it is recommended to resync the signals before use. To perform sync, follow these steps.
a. Cycle ignition on, activate 4-way flashers (leaving them on), cycle the ignition off. All 4-way flashers to run for about 3 minutes. Cycle ignition back on, deactivate 4-way flashers, cycle ignition off. -
Test operation of all lights prior to riding after installation.
WHAT’S IN THE BOX
- Lower fairing inserts
- Lighting t-harness
- Wire management
Having difficulties?
Contact our tech support line at:
Techsupport@metra-autosound.com
Or via phone at:
368.257.1187
TECH SUPPORT HOURS (EST)
Monday-Friday: 9:00AM – 7:00PM
Saturday: 10:00AM – 7:00PM
Sunday: 10:00AM – 4:00PM
MetraOnline.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>