olympia electronics BS-164 Electro Valve Driving Device Installation Guide
- June 12, 2024
- olympia electronics
Table of Contents
olympia electronics BS-164 Electro Valve Driving Device
ΤΕCHNICAL CHARACTERISTICS
OPERATION VOLTAGE| 11-15V DC
QUIESCENT CURRENT| 30mA
INDICATORS| Red LED
OUTPUTS| 4 independent outputs 24V
DEGREES OF COVER PROTECTION| IP20
PRODUCED IN ACCORDANCE WITH| EN 60335-1, EN 50082-1, EN 61000-3-2, EN
61000-3-3
OPERATION TEMPERATURE RANGE| 0 to 60 o C
RELATIVE HUMIDITY| Up to 95%
CONSTRUCTION MATERIAL| ABS, PC
EXTERNAL DIMENSIONS| 114 x 74 x 48 mm
TYPICAL WEIGHT| 150gr.
GUARANTEE| 2 years
Flat cable for connection with BS-1638, BS-1642, BS-1646 panel
GENERAL
The BS-164 is a device that is used to drive electro-valves from a fire
detection panel without using an external power supply.
It can be used only with BS – 680 manually restored electro-valves offered by
olympia electronics.
It is powered from the panels battery. For this reason a special cable, for
connecting the device with the battery, is included in the packaging.
It has 4 independent outputs. Each output is controlled by a separate input.
The device contains an indication LED which is lit when the device is powered. Figure 1 shows the connection via a BS-615 between a fire detection panel BS-1638, BS-1642, BS-1646 one BS-164 and four electro-valves BS-680. Using this specific connection diagram the first electro – valve is controlled by the detectors connected on zone1, the second electro-valve is controlled by the detectors connected on zone2,the third electro-valve is connected on zone3 and the fourth electro-valve is connected on zone 4.
On the BS-636 panel we can connect two independent devices with a common power supply.
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet, which accompanies each product. This warranty ceases to exist if the buyer does not follow the technical instructions included in official documents given by Olympia Electronics or if the buyer modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia Electronics has fully agreed to them in writing. Products that have been damaged can be returned to the premises of our company for repair or replacement, as long as the warranty period is valid. Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or not the buyer the transportation cost.
HEAD OFFICE
72nd km. O.N.R. Thessaloniki-Katerini
P.C. 60300 P.O. Box 06 Eginio Pierias Greece
www.olympia-electronics.com
Info@olympia-electronics.gr
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>