olympia electronics BS-572 Remote Detector LED User Manual
- June 12, 2024
- olympia electronics
Table of Contents
BS-572
**Remote detector LED
**
TECHNICAL SPECIFICATIONS
| Main voltage | connected with “R” of the detector |
|---|---|
| Max. Consumption | 10 mΑ |
| Output | high illumination LED |
| Degrees of cover protection | IP 20 |
| Produced in accordance with | ΕΝ 61000-6-3, ΕΝ 50130-4 |
| Operation temperature range | ο to 60 ºC |
| Humidity | up to 95% relative humidity |
| Dimensions | 68x68x35mm |
| Weight | 50gr. |
| Guarantee | 2 years |
Thank you for your trust in our products
Olympia Electronics – European manufacturer
GENERAL
BS-572 is a remote indicator LED which is co-operated with any detector.
It is installed away from the detector and lights on in case when a detector
is activated.
It is used in buildings that the separated in small places (hotel’s rooms,
hospitals) so as to be controlled easily. Using the BS572 we can realized in
which room there is an alarm without to open the door of the room.
If one room has more than one detectors then we can connect the BS-572 with
all the detector’s so as the LED will be activated when there is an alarm in
one of the detector’s.
The advantage of using the BS-572 is the decrease of the number of the zones
which are necessary for the covering of the building. Usually is installed
away from the room and above of the room door which is to be visible from a
long distance.
Connections
The connection of the LED with the detectors is very simple. When, we finish
with the connection of the detectors to the panel we connect the grip R
(point) of the LED with the grip R (point) of the detector and the + (point)
of the LED with the + (point) of the zone. When we want to connect the LED
with more than one detectors then we follow the above connection for all the
detectors.
In the below scheme is visible the connection of two BS-572 with two
detectors.
921572000_09_013
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>