M-Wave Levitate In LT 150 mm Dropper Seatpost Instruction Manual
- June 12, 2024
- M-WAVE
Table of Contents
**M-Wave Levitate In LT 150 mm Dropper Seatpost Instruction Manual
**
INTRODUCTION
M-Wave ›Levitate In 2‹ dropper seatpost provides riders with an easy way to change the height of saddle. Riders can adjust the saddle height quickly and safely while riding by pressing the lever set on the handle bar. With M-Wave›Levitate In 2‹ dropper seatpost, the saddle position will no longer get in your way of crossing the hill! Please read and follow the instructions of this product manual carefully, and keep this document for further reference.
PACKAGE CONTENT
Dropper seatpost
Remote lever
Cable barrel
Cable casing
Housing Ferrule
Inner cable
Cable end cap
INSTALLATION
-
Route the cable casing through the bike frame.
-
Thread the inner cable through the cable barrel.
-
Thread the inner cable through the cable casing.
-
Hang the cable on the bottom actuator of seatpost as the figures show.
-
Insert the dropper seatpost into seat tube without exposing the safety line
-
Fix the remote lever on handlebar, fasten the screw with 4 mm hex key.
-
Put the cable housing at the end of cable casing and insert into the lever.
-
Thread the inner cable through the remote lever, fasten the screw using a
2 mm hex key. -
Cut the redundant length of the inner cable and fix the cable end with the cable end cap.
OPERATION
To lower seatpost: Press and hold the lever, sit on or push down the saddle, release the lever when the saddle height is suitable.
To raise seatpost: Press and hold the lever, remove the weight on the saddle, release the lever when the saddle height is suitable.
Warning: Do not try to operate the seatpost while aggressive riding.
MAINTENANCE
- Clean the exposed part with a cloth before and after riding.
- Please tighten the connector by hand if the upper and lower tubes are loose. (Using tools to tighten the connector may cause deformation and lead to failure.)
Warning
- Make sure the M-Wave seatpost is the same diameter as the frame of your bike, the incorrect diameter may cause the seatpost to slip or malfunction, leading to severe injury or death.
- After a long period of storage, try it a few times before use to avoid parts failure.
- Do not disassemble or cut the seatpost, or this could cause serious injury and warranty void.
- Do not loosen the connector between the upper and lower tube to prevent sand, dust, oil and water from entering the seatpost.
- If you are not an experienced bicycle mechanic or lack the proper tools for installation, please take the seatpost with this manual to authorized M-Wave dealer and let them deal with the installation.
WARRANTY
This product is warranted to repair or replace defective parts resulting from materials or Manufacturing defects for 2 years from the date of manufacture.
The warranty does not cover the damage or failure caused by abnormal use, modification, improper maintenance, accident, unsuitable operating environment, natural disasters and force majeure.
Notes:
- The warranty applies only to the products purchased new from an authorized M-Wave dealer.
- In no event shall M-Wave be responsible for any direct, incidental or consequential damages, including damages for personal injury, property damage, or economic losses.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>