saunalife EE8G 4-Person Outdoor Barrel Sauna Instruction Manual
- June 12, 2024
- saunalife
Table of Contents
Saunalife EE8G 4-Person Outdoor Barrel Sauna
Product Information
Product Name: Ergo-Series EE8G Barrel Sauna Full Glass Front 79D x 90H
Revision: (1.0)7/2023
Dimensions: 79 inches in diameter and 90 inches in height
Product Usage Instructions
Before starting the construction, please read the manual carefully. Tools
needed for installation: – Measuring tape – Marker pen – Circular saw – Water
level – Hammer – Ratchet strap – Extra hands – Silicone gun (Only for glass-
wall models) – Drill – Crescent wrenchUtility knife – Rubber mallet Use a
piece of wood to protect the plywood. Apply waterproof silicone to the groove.
Mount the glass panels carefully. The cover frame thickness is 0.62. Use DET
1, DET 2, DET 3, and DET 4 brackets for installation. Fix the glass panels
diagonally to make the wall more rigid during installation. Be careful not to
hit the glass with screws. Follow the instructions carefully to avoid any
damage to the glass.
Wooden Back Wall Assembly
Pre-drill holes 0.15 before inserting screws. 2. Use brackets inside for extra
support. 3. Diagonal measurements should be equal for proper assembly.
Position the cradles inside the grooves of the stave 2. 2. Drill 4 holes 0.50
through DET 2 from the outside. 3. Fix temporarily to support walls. 4. Use a
water level to ensure proper installation
Important Notes
The sauna wall configuration depends on your specific model. Please refer to
the wall installation manual for further instructions. – Leave a gap of 0.25
when tightening screws to allow for adjustment when installing the outer bands
(B). – Remove temporary bracing after installation. – Use a strap to support
boards during installation. Please follow these instructions carefully to
ensure proper installation and usage of the Ergo-Series EE8G Barrel Sauna Full
Glass Front 79D x 90H.
Front & Back Walls
EE8G Barrel Sauna 79D” x 90H”
Tools needed
Front glass wall installation
Wooden back wall assembly
EE8G Barrel Sauna 79D” x 90H”
Check walls installation manual on extra pages! Sauna wall configuration depends on Your model!
IMPORTANT! Be sure to leave a .25” gap when tightening screws to leave room for adjustment when the outer bands (B) are installed.
Join two boards together (as shown in diagram II) that will bridge the width of the “A” gap. It is recommended that the combined boards are approximately .25″ wider than the gap
Remove all temporary braces
Use level for installation of benches
EE8G Barrel Sauna 79D” x 90H”
Cut from this side if needed! If Your sauna heater is smaller, You can cut DET 15a to a size, that suits with Your heater.
X= Front wall thickness
Wooden front wall 1.12″
Glass front wall 1.62″
NB! Check also shingles installation manual inside the shingles package
EE8G Barrel Sauna 79D” x 90H”
Documents / Resources
|
saunalife EE8G 4-Person Outdoor Barrel
Sauna
[pdf] Instruction Manual
EE8G 4-Person Outdoor Barrel Sauna, EE8G, 4-Person Outdoor Barrel Sauna,
Outdoor Barrel Sauna, Barrel Sauna, Sauna
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>