comsol WCCK10 Wireless Fast Charging Clock

Overview

| Item|

---|---|---
1| Current time| Displays the current time
2| AM/PM| ‘AM’ light shows after midnight and before noon and ‘PM’ light shows after noon and before midnight
3| Alarm| Lights when alarm has been set and enabled
4| Charging| Lights when device is wirelessly charging

Compatibility

Compatible with Qi-enabled devices* including

• iPhone 12 Pro/Max
• iPhone 12/mini
• iPhone 11 Pro/11
• iPhone SE/XS/XR
• Samsung Note 20/10/9
• Google Pixel 5/4/3
• iPhone X/8/8 Plus
• Samsung S20/S10/S9
• Sony Xperia XZ3
• Xiaomi Mi 10/Mi 9
• LG G8S/G7 ThinQ
• LG V30+/V40

Features

• Supports 10W wireless fast charging for compatible devices such as the Samsung Galaxy Series and more
• Supports 7.5W wireless fast charging for iPhone 8 or later
• Includes an extra USB-A output port to charge another phone, headphones or other USB device
• No need to remove your phone case. Works with most cases up to 3mm thick
• Full safety protection for your devices with Qi certified temperature control, strict voltage regulation & short circuit protection
• Includes AC wall charger and 1.5m USB-A to USB-C cable

Specifications

• Wireless Standard: WPC/Qi (v1.2.4)
• Input: DC 5V/2A 9V/2A
• Wireless Stand Output: 10W / 7.5W / 5W
• Working Frequency: 110 to 205KHz
• Charging Distance: 3 to 8mm
• Charging Efficiency: >70%
• Size: 110mm (L) x 110mm (W) x 26.5mm (H)
• Weight: 170g
• Certifications: RCM, RoHS, UN38.3

Set Clock Time

• Press the M button to cycle through clock, alarm 1 and alarm 2 modes. When the : LED is flashing, it is in CLOCK mode.
• Press the S button, the hour LED will flash. Press or to adjust the hour.
• Press the S button, the minute LED will flash. Press or to adjust the minute. Repeat to adjust next minute LED.
• Press the S button again to confirm time setting.

Set Alarm Time

• Press the M button to cycle through clock, alarm 1 and alarm 2 modes. When the : LED is not flashing, it is in ALARM mode. Press the S button, the hour LED will flash. Press or to adjust the hour.
• Press the S button, the minute LED will flash. Press or to adjust the minute. Repeat to adjust next minute LED.
• Press the S button again, the LED will appear.
• To turn the alarm on or off press or . When the LED is flashing the alarm is OFF and when it is not flashing the alarm is ON. Press the M button to confirm the alarm setting.

Turn Off Alarm
When the alarm is sounding, press any button , , S or M to turn off the alarm.

Snooze Alarm
The two front feet under the clock act as a snooze button. When the alarm is sounding, press down on the front of the clock to snooze the alarm for 10 minutes.

Adjust LED Brightness
Press or to adjust the LED brightness. There are four levels: off, low, mid and high.

Charging a Phone

• Place your phone on the charging pad and charging should start automatically.

•  If your phone does not start charging, move your phone until the correct position is found and your phone starts charging.

• The wireless charging icon will show the charging status.

• To charge another device using the USB-A output on the back of the clock, use your device’s charging cable and connect to the USB-A output.

Please Note: When wirelessly charging a device, the wireless charger and your device may feel warm. This is a normal operating condition and should not be cause for concern.

Important Safety Instructions

• Only use the original wall charger and cable that was supplied with the charging clock

• Only use the product for the specified purpose of use

• Do not get wet to avoid causing short circuit damage and leakage

• Do not use in extreme hot, humid or corrosive environments to avoid short circuit damage and leakage

• Do not place too close to magnetic strip or chip ID card to avoid magnetic failure

• Do not place within 20cm of implantable medical devices (pacemaker, cochlear implant etc.) to avoid potential interference

• Do not clean with harmful chemicals or detergents

• Misuse, dropping or excessive force may cause damage to the charging dock

• Do not use the product if it is damaged or emits a suspicious odour

• Unplug the product from power sources when not in use

• Check with device manufacturer for Qi wireless compatibility
  iPhone is a trademark of Apple Inc., registered in the U.S. and other countries.
  The ‘Qi’ Symbol is a trademark of the Wireless Power Consortium.
  www.mycomsol.com.au

References

• Comsol Retail

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>