Genmitsu 710W Spindle Motor Compact Trimmer Router Installation Guide

Genmitsu 710W Spindle Motor Compact Trimmer Router

Welcome

Thank you for purchasing the 71 OW Compact Router from SainSmart.
For technical support, please email us at support@sainsmart.com.
Help and support is also available from our Facebook group. (SainSmart Genmitsu CNC Users Group) Scan QR code to find information.

Warning

1. Please read the instruction manual carefully before use.
2. Check that the power cord cannot be pulled within the spindle’s range of motion before operation to avoid the spindle tool touching the power cord.
3. The socket must be mated to the spindle plug and the plug must never be modified in any way.
4. Do not expose the spindle to rain or moisture.
5. When replacing the spindle, be sure to lock the spindle set screws, otherwise, damage to the spindle and personal injury may result.
6. The shank of the tool to be used shall be matched to the collet.
7. Allow the spindle to idle to the set speed before the tool touches the engraved material. (Note that vibration or wobbling may indicate improper tool installation in the spindle)
8. Before removing the workpiece from the table, be sure to turn off the power and wait for the spindle tool to come to a complete stop.
9. Do not touch the spindle immediately after the work is completed, as the high temperature of its operation may burn your skin.

Safety Guideline

• Remain alert when operating the spindle! Always pay attention to the operation being performed and remain sober. Never operate the spindle while fatigued or reacting to drugs, alcohol, or treatment.
• Always wear goggles during operation to prevent eye injury from flying debris.
• Do not wear gloves while operating the spindle to prevent them from getting caught in the cutter and injuring your hands.
• Be careful when loading and unloading the spindle’s cutters, as they are very sharp and can easily injure your hands.
• If chip conveyor or dust collector units are to be connected, make sure that they are properly connected and used.
• Wear noise protection equipment such as ear muffs when operating for long periods.
• Avoid wearing loose clothing while operating and keep your hair and clothing away from moving parts
• Keep children or others away from the spindle when it is in operation.

Working Environment

• Keep the workspace clean and bright.
• Do not operate the spindle in explosive environments such as those with flammable liquids, gasses, or dust.
• Operate the spindle after allowing children and bystanders to leave.

Package List

Dimension

Specification Parameter

Collet Replacement Instruction

1. Remove the collet nut.
2. Press the collet in the direction of the arrow to separate it from the collet nut.
3. Place the collet to be replaced in the collet nut and push the collet into the collet nut in the direction of the arrow until a click is heard, indicating that the collet is in place.

Tool Disassembly and Installation

1. Use a wrench to loosen the collet nut.
2. Insert the tool into the spindle chuck.
3. Use a wrench to lock the collet nut tight.

Carbon Brush Replacement Instruction

When the carbon brushes are worn out and need to be replaced, the 2 carbon brushes on the left and right sides should be replaced at the same time. Replace the carbon brushes with the same specifications as the original carbon brushes.

1. Use a slotted screwdriver to remove the carbon brush clip covers on the left and right sides.
2. Remove the 2 worn carbon brushes, install new carbon brushes, and then install the carbon brush holder cover.

• Email: support@sainsmart.com
• Facebook messenger: https://m.me/SainSmart
• Help and support is also available from our Facebook Group Vastmind LLC, 5892 Losee Rd Ste. 132, N. Las Vegas, NV 89081

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>