BEGA 22613 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 22613 Wall Luminaire Instruction Manual
Wall luminaire
Instructions for use
Application
Shielded wall luminiaire with high protection class for a variety of lighting
tasks.
A luminaire made of die cast aluminium and impact resistant crystal glass with
light diffusing structures.
Product description
- Luminaire made of aluminium alloy and stainless steel
- BEGA Unidure® coating technology Crystal glass with optical structure 2 mounting holes ø 5.3mm
- Distance apart 90mm 2 cable entries for through-wiring of mains supply cable ø 7-10.5mm
- Connection terminal 2.5@
- Earth conductor connection
- Lampholder E 27
- Safety class I
- Protection class IP 65
- Dust-tight and protection against water jets Impact strength IK07
- Protection against mechanical
- impacts < 2 joule
- Safety mark
- Conformity mark
- Weight: 2.5 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Lamps
- Luminaire with screw base E 27
- Lamp output max. 2 × 60 W
- This product contains light sources of energy
- efficiency classes E, F
- Supplied lamp
- 2 × BEGA LED lamp 13584
- LED Retrofit 7 W · 1610 lm · 3000 K
- Luminaire efficiency: 27%
Additional BEGA LED lamps are available for this luminaire:
13 586 LED 7 W · 805 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
Undo screws.
Remove cover and glass with gasket.
Lead the mains supply cable through the
cable entry into the luminaire back housing.
Note position of application of the luminaire »arrow down«.
Fix luminiare back housing with enclosed or any other suitable fixing material
onto the mounting surface.
It is absolutely essential to use the enclosed gaskets.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection. Insert
lamp.
Insert cover with glass and gasket.
Make sure that the gasket is in correct position. Tighten screws evenly.
Relamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary. Close the luminaire.
For cleaning, do not use high pressure cleaners.
Spares
Spare glass: 11 002 459 11
LED lamp 3000K: 13 584
Lampholder: 63 000 052
Gasket: 83 000 533 .1
2/2 BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden ·
info@bega.com
www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>