BEGA 31455 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 31455 Wall Luminaire Instruction Manual
Wall luminaire
Instructions for use
Application
Wall luminaire made of copper with doublesided light exit. Fully glare free
light for lighting wall surfaces.
For interior or exterior lighting design.
Product description
- Luminaire made of copper, brass and stainless steel
- pal glass
- Silicone gasket
- Reflector made of pure anodised aluminium 2 mounting holes ø 4.5mm Distance apart 212mm
- 1 cable entry for mains supply cable up to ø 10,5mm
- Connection terminal 2.5@
- Earth conductor connection
- Lampholder E 27
- Safety class I
- Protection class IP 54
- Protection against harmful dust deposits and splash water
- Safety mark
- Conformity mark
- Weight: 2.1 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Lamps
- Luminaire with screw base E 27
- Lamp output max. 2 × 60 W
- This product contains light sources of energy efficiency classes E, F
- Supplied lamp
- 2 × BEGA LED lamp 13584
- LED Retrofit 7 W · 1610 lm · 3000 K
Luminaire efficiency: 34%
Additional BEGA LED lamps are available for this luminaire:
13 586 LED 7 W · 805 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
To avoid fingerprints on the luminaire use enclosed protective gloves during
installation. Undo screws and remove shield and glass. Lead the mains supply
cable through the cable entry into the luminaire back housing.
Note the position of application »arrow down«.
Fix the luminaire back housing with enclosed or any other suitable fixing
material onto the mounting surface.
It is absolutely essential to use the enclosed gaskets.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection. Insert
lamp.
Make sure that the gasket is in correct position. Place the glass and shield
onto the luminaire back housing and tighten with screws.
Relamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary. Close the luminaire.
For cleaning, do not use high pressure cleaners.
Copper
The luminaire parts made of solid copper are delivered with the metal’s
natural surface colour.
Time and weather factors create the natural patina characteristic for copper.
Spares
Spare glass: 11 002 717 .1
LED lamp 3000K: 13 584
Lampholder: 63 000 052
Reflector: 76 000 678
Gasket: 82 000 372
2/2 BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden ·
info@bega.com
www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>