BEGA 33 186 Light Brick Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
33 186
**Lichtbaustein®
IP 44
Instructions for use**
Application
Lichtbaustein®
Ceiling and wall luminaire for many lighting tasks.
Ideal for places where a soft and uniform lighting distribution is required.
For interior and exterior applications.
Product description
Luminaire made of aluminium alloy and stainless steel
BEGA Unidure® coating technology
Opal glass
2 mounting holes ø 5 mm
Distance apart 245 mm
2 cable entries for through-wiring of mains supply cable ø 7-10.5 mm
Connection terminal 2.5@
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies
≥ 1 mm and splash water
Impact strength IK05
Protection against mechanical
impacts < 0.7 joule
– Safety mark
– Conformity mark
Weight: 1.4 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation. If subsequent modifications are made to the luminaire, the
person responsible for these modifications shall be considered the
manufacturer.
Lamps
Luminaire with screw base E 27
Lamp output max. 2 × 40 W
This product contains light sources of energy
efficiency classes E, F
Supplied lamp
2 × BEGA LED lamp 13 584
LED Retrofit 7 W · 805 lm · 3000 K
Luminaire efficiency: 56%
Additional BEGA LED lamps are available for this luminaire:
13 586 LED 7 W · 805 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data
sheets on our website.
Installation
Lead the mains supply cable through the cable entry of the luminaire base.
Fix luminaire base with enclosed or any other suitable fixing material onto
the mounting surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamp.
Snap the opal glass into the lower spring clips, centralise and push into the
upper spring clips.
Relamping Maintenance
Disconnect the electrical installation.
Pull glass out of the spring clips and remove from the luminaire back housing.
Clean the glass and luminaire housing using only suitable cleansers.
When cleaning please do not use high pressure cleaners.
Change the lamp.
Snap the glass into the lower spring clips, centralise and push into the upper
spring clips.
Spares
| Spare glass | 11 002 431 .1 |
|---|---|
| LED lamp 3000K | 13 584 |
| Lampholder | 63 000 052 |
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com