Rubine RCH-MARK X-BL Cooker Hood User Manual

June 12, 2024
Rubine

Rubine RCH-MARK X-BL Cooker Hood User Manual

Customer Care

FIG 1 Customer Care .JPG

Our Warranty

FIG 2 Our Warranty.JPG

SPECIFICATIONS

  • Model Name: RCH-MARK X-BL
  • Total Power: 240W
  • Motor Power: 238W
  • LED Lamp: 1×2W
  • Voltage: 220-240V
  • Frequency: 50Hz
  • Control Panel: Sensor Touch Control

PRODUCT DIMENSION

FIG 3 PRODUCT DIMENSION.JPG

PRODUCT PARTS DIAGRAM

FIG 4 PRODUCT PARTS DIAGRAM.JPG

FIG 5 PRODUCT PARTS DIAGRAM.JPG

INSTALLATION REQUIREMENT

  1. Do not install the cooker hood where there are many doors or windows in order to avoid affecting the exhaust efficiency of the hood caused by air convection. (refer Fig. 1)
  2. Install the cooker hood right above the hob. The recommended distance between the hob and the lower edge of the cooker hood is minimum 300 mm and maximum 350mm. (Fig. 2)
  3. In order to get the optimum performance, do not elongate the exhaust pipe too long, avoid over-bending of exhaust. Ensure the connection is airproof. (Fig. 3)
  4. After hanging the unit on the wall, ensure the hood’ level is vertically straight. (Fig. 4)
  5. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must be under no circumstances, be connected to ventilation ducts in which fuel-burning appliances are installed.

FIG 6 INSTALLATION REQUIREMENT.JPG

INSTALLATION PROCEDURES

Please carefully read the following diagram before installation, and install in accordance with the steps to ensure the smooth installation of the product.

FIG 7 INSTALLATION PROCEDURES.JPG

FIG 8 INSTALLATION PROCEDURES.JPG

FIG 9 INSTALLATION PROCEDURES.JPG

FIG 10 INSTALLATION PROCEDURES.JPG

FIG 11 INSTALLATION PROCEDURES.JPG

FIG 12 INSTALLATION PROCEDURES.JPG

Installation confirmation: after installation, check the hood whether it is solid, turn the power on and test it, exam in the function whether it is normal and whether there is abnormal vibration of the body, after confirmation can be used.

CHARCOAL FILTER INSTALLATION & REPLACEMENT

  1. The charcoal filters should be replaced when it is noticeably dirty or discolored, usually after 6 to 12 months depending on the conditions of use.
  2. These filters are not washable and cannot be restored. To ensure that this appliance functions effectively, regular maintenance is necessary as clogged filters restrict airflow and may cause the motor to overheat.
  3. Removing and inserting the charcoal filter:
    Take the baffle filter apart, hold onto the air intakes and turn slightly.
    Once the charcoal filter turns out of the screw, remove directly.

OPERATING INSTRUCTIONS

FIG 13 OPERATING INSTRUCTIONS.JPG

FIG 14 OPERATING INSTRUCTIONS.JPG

MAINTENANCE

CAUTION: NEVER PUT YOUR HAND INTO THE AREA WHILE THE FAN IS OPERATING. TO GAIN OPTIMAL LEVEL OF HOOD PEFORMANCE, CLEAN THE COOKER HOOD SURFACE, FAN AND OIL FILTER REGULARLY.

  1. Use only mild soap or detergent solutions to clean the cooker hood surface.

  2. Clean the filter depending to usage or at least once a week. Press the buckle of the filter slightly, take off the filter and put it into warm soapy water using mild detergent, lightly brush the filter with soft brush. Place the filter back after it is dry.

  3. Clean the fan motor and others internal parts twice a year or depending to usage by QUALIFIED PERSONNEL.

  4. DO NOT clean the motor with water or other liquid.

  5. the appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.

  6. children being supervised not to play with the appliance.

  7. there shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.
    CAUTION: Accessible parts may become hot when used with cooking appliances.

  8. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.

  9. Regulations concerning the discharge of air have to be fulfilled.

  10. The range hood is only intended to be installed over a hob with no more than four hob elements.

TO REPLACE LED LAMP

CAUTION: The lamp may be hot! Wait until unit is cool. If the lamps malfunction, please replace it with a new lamp. Make sure all the control is switches off and the cooker hood is unplugged!

Please follow below instructions:

  1. Take out the filters, and cut off the wire connection of the lamp.
  2. Press the spring according to the arrow direction, then you can take off the lamp unit.
  3. You can replace a new LED lamp unit no more than rating!
  4. Then put the lamp unit to the hood in reverse direction. Connect the wire of the lamp.
  5. Fit on the filters.

IMPORTANT SAFETY INSTRUCTIONS:

FIG 16 IMPORTANT SAFETY INSTRUCTIONS.JPG

FIG 17 IMPORTANT SAFETY INSTRUCTIONS.JPG

FIG 18 IMPORTANT SAFETY INSTRUCTIONS.JPG

FIG 19 IMPORTANT SAFETY INSTRUCTIONS.JPG

TROUBLESHOOTINGS

CAUTION: Disconnect the power supply before servicing.

FIG 20 TROUBLESHOOTINGS.JPG

FIG 21 TROUBLESHOOTINGS.JPG

WARRANTY CARD

WARRANTY CONDITIONS
Subject to following Term & Conditions, this equipment is guaranteed against defective material & manufacturing defects by Fiamma Trading Sdn Bhd for a period of twelve (12) months from the date of original purchase. Fiamma Trading Sdn Bhd reserves the right to change these terms & conditions without prior notice.

Terms & Conditions:-

  1. This warranty is va id & provided that warranty card is completed with authorized dealer’s stamp from the date of original purchase and in the territory of Malaysia only.

  2. This warranty covers repair or, at the option of Fiamma Trading Sdn Bhd, replacement of any parts proven to be defective due to defective workmanship or material provided that the product was purchased from an authorized dealer of Fiamma Trading Sdn Bhd

  3. This warranty does not cover the damage resulting from:
    (a) Any unauthorized disassembly, service repair, alteration or modification being carried out
    (b) Abnormal voltage or the use of generator and/or used not in accordance with the Operating Manual / Userl Manual.
    (c) Misuse, abuse, negligence or accident howsoever caused
    (d) Normal wear or tear.
    (e) Rough hand ing & transportation.
    (f) Commercial / public use e.g. hotel, laundry, college, university, etc

  4. This warranty does not cover the following accessories:
    (a) Burner Caps/Supports (b) Cast Iron Grib (c) Knobs (d) Body Work (e) Light Bulb (f) Charcoal / Filter (g) Cover (h) Glass Cover / Screen (i) Trays/Shelves (j) Hose

  5. This warranty is considered null & void in the events if:
    (a) Any item contained in this warranty card has been tempered with or altered in any way without the prior written consent of Fiamma Trading Sdn Bhd. Request for warranty services within the warranty period must be accompanied with this warranty card & proof of original purchase.

FIG 22.JPG

rubine.com.my
FIAMMA TRADING SDN BHD  (A330476-P (A member of Hamma Holdings Berhad)

9-2, Wisma Fiamma, No.20, Jalan 7A/62A, Bandar Manjalara, 52200 Kuala Lumpur. Tel: 03-6279 8943

Dear valued customer,
Thanks for your purchase of our product.
PLEASE READ & KEEP THIS USER MANUAL

Please note that this product is marked with this symbol:
According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should separately collect and treat. If in future you need to dispose this product, PLEASE DO NOT disposes it with household waste.
Please send it to WEEE collection point.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals