Rubine RCH-MONZA X-BL Cooker Hood User Manual

Rubine RCH-MONZA X-BL Cooker Hood User Manual

SPECIFICATIONS

Model Name: RCH-MONZA X-BL
Total Power :360W
Motor Power: 268W
LED Lamp: 1X2W
Voltage:220-240V
Frequency:50Hz
Control Panel: Sensor Touch Control

PRODUCT DIMENSION

PRODUCT PARTS DIAGRAM

INSTALLATION REQUIREMENT

1. Do not install the cooker hood where there are many doors or windows in order to avoid affecting the exhaust efficiency of the hood caused by air convection. (refer Fig. 1 )
   

2. Install the cooker hood right above the hob. The recommended distance between the hob and the lower edge of the cooker hood is minimum 650 mm and maximum 700mm. ( Fig. 2)
   

3. in order to get the optimum performance, do not elongate the exhaust pipe too long, avoid over-bending of exhaust. Ensure the connection is airproof. (Fig. 3)
   

4. After hanging the unit on the wall, ensure the hood’ level is vertically straight. ( Fig. 4)
   

5. The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must be under no circumstances, be connected to ventilation ducts in which fuel-burning appliances are installed.

INSTALLATION PROCEDURES

please carefully read the following diagram before installation, and install in accordance with the steps to ensure the smooth installation of the product.

According to the dimension of installing bracket, on the walls in the corresponding position to accurately determine the position of an installing hole, use a $10 impact drilling out the mounding holes, and firmly buried expanding tube, then use the M5x50 wood screws fastening the installing bracket tothe wall.

Embed the clasp on the outlet joint with a step at one end, then align the clasp on the outlet and press the clasp to the bottom.

Pick the cooker hood up,the hanging hole at the back of the box assembly is aligned with the hanger on the installing braket, and the limiting screw in the accessory bagis fixed on the hole of the installing bracket to prevent the accidental fall of the hood.

Pull the inner duct cover to a suitable height and secure the inner duct cover from the side to the installation bracket with the cross screwdriver.

If you need connect the common flue, please do not put the exhaust pipe too deeply ,so as to not affect the effect.

If you connect the exhaust pipe to outdoor, please push it out of the wall at least 30mm, the air outlet should be slightly adown, to avoid rain water intrusion.

CHARCOAL FILTER INSTALLATION & REPLACEMENT

1. The charcoal filters should be replaced when it is noticeably dirty or discolored, usually after 6 to 12 months depending on the conditions of use.
2. These filters are not washable and cannot be restored. To ensure that this appliance functions effectively, regular maintenance is = necessary as clogged filters restrict airflow and may cause the motor to overheat.
3. Removing and inserting the charcoal filter: Take the baffle filter apart, hold onto the air intakes and turn slightly. Once the charcoal filter turns out of the screw, remove directly.
   

OPERATING INSTRUCTIONS

When it is Power-Up state, touch this key into standby mode and the indicator lamp flashes; touch this key again to exit standby mode; At the motor working state, touch this key and the indicator lamp flashes, then the machine continue to operate 3 minutes. After the delay, power will be cut off automatically(including light) ; at the delay state, touch this key and the power will be cut off (Lighting nonincluded) .

In the standby mode, Press this key to enter high speed, press again to enter low speed.

In the standby mode, touch this key to enter boost function, three minute later or touch this key again return to high speed; in the motor working state, exit the boost function will return to original speed.

MAINTENANCE

CAUTION: NEVER PUT YOUR HAND INTO THE AREA WHILE THE FAN IS OPERATING. TO GAIN OPTIMAL LEVEL OF HOOD PEFORMANCE, CLEAN THE COOKER HOOD SURFACE, FANAND OIL FILTER REGULARLY.

1. Use only mild soap or detergent solutions to clean the cooker hood surface.

2. Clean the filter depending to usage or at least once a week. Press the buckle of the filter slightly, take off the filter and putitinto warm soapy water using mild detergent, lightly brush the filter with soft brush. Place the filter back after it is dry.

3. Clean the fan motor and others internal parts twice a year or depending to usage by QUALIFIED PERSONNEL.

4. DO NOT clean the motor with water or other liquid.

5. the appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.

6. children being supervised not to play with the appliance.

7. There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.
   CAUTION: Accessible parts may become hot when used with cooking appliances.

8. The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.

9. Regulations concerning the discharge of air have to be fulfilled.

10. The range hood is only intended to be installed over a hob with no more than four hob elements.

TO REPLACE LED LAMP

CAUTION: The lamp may be hot! Wait until unitis cool. If the lamps malfunction, please replace it with a new lamp. Make sure all the control is switches off and the cooker hood is unplugged! Please follow below instructions:

1. Take out the filters,and cut off the wire connection of the lamp.
2. Press the spring according to the arrow direction,then you can take off the lamp unit.
3. You can replace a new LED lamp unit no more thanrating!
4. Then put the lamp unit to the hood in reverse direction. Connect the wire of the lamp.
5. Fit on the filters.
   

IMPORTANT SAFETY INSTRUCTIONS:

check the connection between air inlet and wind chamber whether it is sealed or not.
b )Check the connection between air exhaust pipe and wind chamber whether there is leakage of oil or not. If YES. please fill t up with the varnish or thinner.
c)I1 the motor stops running and has a bad odor after a moment of operation, the motor wires may be burnout. Please replace motorsill( the starting wire (yellow) is disengaged from the condenser, it needs to be rewired
E) ll the condenser isdamaged, please replace with a new one.| …. .’3“screwdriver
Machine
vibration| a )lf the motor were not finny screwed. tighten the screw up.
b )11 the vane is damaged or unbalanced. replace with a new one.| “+” typescrewdriver
Weak suction| a )The distance is too far between the cooker hood and hob.
b )There are many windows (doors) causes strong wind convection.
c) If due to the position of cooker hood Install upon the window, you may put a three-ply board on the bad( of the cooker hood to cover the spaces.| “+”w    type     .screwdriver.
Tilting hoed| a) Aciust the height of the model where it is hung on the ceiling.
b) tlf the model tilt (award. lock the wall with wood screw again (the screw peep out around 0.5-1 . CM from the wall). a check the screw that fixing the model are loose or not| “*”   typescrewdriver
Lamp does not light-up| Take the saew oft from the lamp shade and replace with a new light bulb. then fix the lamp shade back.| “+ type
screwdriver

Please note that this product is marked with this symbol: According to Waste of Electrical and Electronic Equipment (WEEE) directive, WEEE should separately collect and treat. If in future you need to dispose this product, PLEASE DO NOT disposes it with household waste. Please send it to WEEE collection point.

WARRANTY CARD

WARRANTY CONDITIONS Subject to following Term & Conditions, this equipment is guaranteed against defective material & manufacturing defects by Fiamma Trading Sdn Bhd for a period of twelve (12) months from the date of original purchase. Flamma Trading Sdn Bhd reserves the right to change these terms & conditions without prior notice.

Terms & Conditions:

1. This warranty is valid & provided that warranty card is completed with authorized dealer’s stamp from the  date of original purchase and in the territory of Malaysia only

2. This warranty covers repair or, at the option of Fiamma Trading Sdn Bhd, replacement of any parts proven to be defective due to defective workmanship or material provided that the product was purchased from an authorized dealer of Fiamma Trading Sdn Bhd.

3. This warranty does not cover the damage resulting from:
   a)Abnormal voltage or the use of generator and/or used not in accordance with the Operating Manual/User Manua
   (c) Misuse, abuse, negligence or accident howsoever caused.
   (d) Normal wear or tear.
   (e) Rough handling & transportation.

4. (@) Burner Caps/Supports (b) Cast Iron Grib (c) Knobs (d) Body Work () Light Bulb (1) Charcoal Fiter (g) Cover () Glass Cover / Screen () TraysiShelves () Hose This warranty is considered null & void in the events I (a) Any item contained i this warranty card has boen tempered wih or altered in any way withou the prior witien consent of Fiamma Trading Sdn Bhd. Request for warranty services within the warranty period must be accompanied wih this warranty card & proof of original purchase.

5. Any time during the warranty period, any part / parts of this equipment is / are removed, altered, tempered with, adjusted, modified, dismanted, repaired or handled in any way whalsoever by any person / persons not authorized by us
   (c) The serial number of the product has been defaced o removed.

6. Warranty for WINE CHILLER compressor i

7.  ive years, gas refill and labor charges are excluded.  In the event of defects covered by this warranty arising during the warranty period, the purchaser shall be fully responsible for the due delivery o our dedicated service ceiler of the equipment (expect for the refrigerator, washing machine, ovens, cooker hood, gas Gooker, dishwasher, dryer, baiting hob, freezer, water heater) or any work which shall need to be done pursuant

8. this warranty & subsequent collation thereof of the equipment after the said work has been done. This warranty is in lieu of any, and all other warranties expressed or implied warranty of merchantability or fines for a partcular purpose. Fiamma Trading Sdn Bhd assumes no liabilty for the breach of the warranty beyond correcting the breath in the manner described above. In no event shall Fiamma Trading Sdn Bhd be finable for consequential losses or damages, including loss of use or loss of profs resultng fom the product

FOR OFFICE USE

Model Name:___
Serial No  Barcode:____
Customer’s Name (In Block/Full Name):__
Date of Purchase :____Day____ MTH__ YR

Customer’s Address (Full Address):___
Post Code:__ State:____
Customers Tel No : (H)__ (©)____
Customer’s Email :_ [ HP)__

Authorised dealer’s stamp
Fiamma Trading Sdn. Bhd,___

Customer Signature____

Hotline: 03-6286-9000
Email: eqgservice@fiamma.com.my

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>