Rubine ITALIA RCE-ROSSE42 Built In Ceramic Hob User Manual

: May 15, 2024
: Rubine ITALIA

RCE-ROSSE42 Built In Ceramic Hob

USER MANUAL

MODEL: RCE-ROSSE42-BL
SERIAL NO.

BUILT-IN CERAMIC HOB

Self-diagnostic Function

The product will be alarm, then automatically shut down or stop to heating.
And the product also displayed error code. If the problem can not be solved please consult the
service centre and do not try to throw off the unit by yourself.
The error code list as below :

ERROR CODE LIST :

E0 : The voltage is too low.
E1 : The voltage is too high.
E2 : The temperature on cooker surface is too high.
E3 : The IGBT temperature is too high.
E5 : The temperature sensor for cooker surface is short circuit or open circuit.
E6 : The temperature sensor for IGBT is short circuit or open circuit.
E7 : No cookware/pan put on hob surface

Caution

Thanks for your purchasing at our product.
Please take note that this product is for indoor household use only.
Please read this instruction manual carefully before using the product in order to ensure
safe and correct use of this product.

INSTRUCTIONS FOR USE

This appliance is not suitable for persons (including children) with reduced physical, sensory or
mental capabilities or lacking in experience and knowledge, unless they have been given
supervision or instruction concerning the use of the appliance in a safe way, and understand the
hazards involved.
If you have been fitted with a cardiac pacemaker, please consult your doctor for advice on
whether or not it is safe for you to operate this appliance.
Do not allow children to play with the appliance.
Do not let children clean and/or maintain this appliance unless they are strictly supervised with
clear instructions.
Before installing, maintaining, and repairing this appliance, make sure to disconnect the power
supply first.
DO NOT use the appliance if the power cord or the power plug has been damaged, or if the
interface between the power sockets and the power plug is loose.
If the power cord is damaged, in order to avoid risk of bodily injuries, it must be replaced by the
manufacturer i.e. its technicians, maintenance professionals or similar.
DO NOT damage either the power cord or power plug.
DO NOT immerse cord, plug or unit in water or any other liquids.
DO NOT allow the wire cord to hang over the edge of the table or counter, or any heated
surfaces.
DO NOT use extension cords to operate the appliance; use individual electric supply socket.
Make sure that the appliance and its corresponding electrical components are installed
correctly before use.
DO NOT alter, dismantle or repair the appliance without the express consent of the
manufacturer; all unauthorized attempts to do so is prohibited to ensure user safety.
Make sure to use this appliance on a firm, flat and heat resistant surface.
DO NOT place near hot gas.
When using this appliance, basic safety precautions should always be followed; checkthe
voltage indicated on the rating plate corresponds with that of your local voltage before
connecting the appliance to the main power supply.
When the power is switched ON, this appliance will get very hot; be careful when using to avoid
scalding and burning.
DO NOT use the appliance to cook explosible food.
DO NOT place any metal contents on the appliance while operating.
DO NOT touch the control panel with any sharp objects.
In case of operational abnormalities or malfunctionings, please stop using it and pull out the
power plug immediately.
Allow to cool before putting on or taking off parts, and before cleaning.
DO NOT use cleaners containing irritants or with corrosive detergents, or sharp metal scrapers
to clean the appliance.

Troubleshooting Guide

Symptoms	Possible Cause	Solutions

Display flashing when
connect electric| Work smoothly| No problem
The fans still run a few
minutes after turn off the
products| Cooling the temperature for
heat inside hob| No problem
The item surface still keep
warm, even after switched
off| Heat residual display ‘H’| No problem
No work and no display| Not connected electricity
or no electricity|

Ensure all everything
supply working well

The display work normally
but can’t operate| The problem of PCB|

Contact after-sales
service department.

Open one burner, the
display shows “E7” with
buzzing| The pot not suitable for
induction cooking|

Change to other suitable

The pot have noise during
cooking| The noise is vibration which is
from the induction cooker
imparted energy to pot| No problem
The induction cooker have
taste in the first time use| It is a new appliances|

Boil water for half an hour
to remove abnormal smell
on pot

Cleanness and maintenance

Please turn OFF and unplug the appliance before starting any cleaning or maintenance work.
Please leave the appliance to completely cool before cleaning.
Please use soft cloth for cleaning stains on glass plate and panel.
Please use damp cloth and mild detergent for cleaning grease stains and blots.
DO NOT use high voltage vacuum cleaner or air cleaner to clean the appliance.
Please clean gas vent regularly to prevent the accumulation of dust and dirt.
Always check to make sure that connection between appliance plug and power socket is fast and secure
before using.
DO NOT pull the power cord to unplug.
Please note that Cooling Fan will still be operating after power is turned OFF and appliance is left to cool.
Please check to make sure that the bottom of cooking pots or pans are not rough and uneven to avoid
possibly scratching the glass panel.
DO NOT place hot pots and pans on any non-heating areas of the appliance.

ADDITIONAL IMPORTANT NOTES

Connect this appliance to a 220-240V electrical outlet only.
When this appliance is in use:
a) DO NOT allow curtains, wall coverings, clothing, dish towels or any other flammable
materials be in close proximity;
b) DO NOT place cleaning agents, solvents or any other flammable liquids anywhere near;
c) DO NOT leave unattended; and
d) DO NOT under any circumstances cover the gas vent.
If any cracks are detected on the surface, shut down the appliance immediately to avoid the
risk of injuries from electrical shock.

WARNING

Misuse of this appliance may cause injuries.
DO NOT heat empty pots on the heating zone.
DO NOT put pressure on the heating plate to avoid possible impact damage.
The temperature of all accessible surfaces may be high when the appliance is in use;
exercise caution to avoid scalding and burning.
The glass plate is hot after use, please DO NOT touch; exercise caution to avoid scalding
and burning.
DO NOT switch OFF the power supply immediately after use; wait at least 30 seconds for
the Cooling Fan to work on cooling the appliance.
Always switch OFF the appliance before leaving it unattended.

Parts and Feature

c) Slide
i) Use to adjust the “Power” level:
• “Slide” from left to right to increase power to a higher level; and
• “Slide” from right to left to decrease power to a lower level
• Power levels are on a scale of 1-9
d) Timer
i) Use to adjust the “Timer”:
• Turn ON the appliance;
• Select your desired “Power” level;
• Press “Timer” to set cooking duration
• Press “+” or “-” to select cooking time–selected duration will be displayed on the LED
screen for a few seconds, after which the appliance will start counting down;
• Once the set cooking duration is reached, the appliance will automatically turn OFF
• Timer : 0-99 mins
e) Lock
i) Use to lock the Control Panel:
• Press and hold for about 3 seconds to activate the “Lock” function; all buttons are now
locked except ON/OFF
ii) To unlock:
• Press and hold again for about 3 seconds to deactivate the “Lock” function;
f) Inner/Outer Ceramic Cooker(Right side)
Ring Control i) Use to select the inner, outer or both inner and outer heating zones for
Ceramic Cooker ONLY:
• Turn ON the appliance;
• Select your desired Power level;
• Press “Inner/Outer Ring Control” to select either inner, outer or both
heating zones

How to use

1. Cookware Selection
a) i) CERAMIC HOB – Steel, cast iron, enameled iron, stainless steel, and ceramic cookware

ii) INDUCTION HOB – the cookware must have an iron base
iii) Aluminium pot or pan is NOT recommended.
b) Flat-bottomed pot or pan

c) Flat-bottomed pot or pan 12cm to 26cm in diameter

Note: Please select the most suitable pot or pan for Ceramic or Induction use.
d) DO NOT use tinfoil or plastic cooking materials, as these may melt, and possibly leave
permanent marks on the glass surface.
Caution

2. Avoid dragging pots and/or pans across the panel to avoid possibly scratching the glass.

3. Cookware Selection
a) i) CERAMIC HOB – Steel, cast iron, enameled iron, stainless steel, and ceramic cookware
ii) INDUCTION HOB – the cookware must have an iron base
iii) Aluminium pot or pan is NOT recommended.
b) Flat-bottomed pot or pan
c) Flat-bottomed pot or pan 12cm to 26cm in diameter
Note: Please select the most suitable pot or pan for Ceramic or Induction use.
d) DO NOT use tinfoil or plastic cooking materials, as these may melt, and possibly leave
permanent marks on the glass surface.
Caution
Avoid dragging pots and/or pans across the panel to avoid possibly scratching the glass.
Control Panel Operation Instruction
a) ON/OFF
i) Press to turn the the appliance power ON or OFF
ii) Once “ON/OFF” is pressed, the appliance will emit a ‘BEEP’ sound, and the red light will
turn ON
iii) The appliance is now in “Standby” mode; you may select your desired power for heating
iv) If no operation is selected in 10 seconds, the light will go off
v) Press “ON/OFF” again to turn OFF the appliance; red light will turn OFF too.
b) i) Press to adjust the “Power” or “Timer”:
• “+” to increase “Power” or “Timer” to a higher level; and
• “-” to decrease “Power” or “Timer” to a lower level

Technical Specification

Model RCE-ROSSE42-BL
Voltage 220-240V
Rated Power 4200W
Rated Frequency 50-60Hz
Product Size (mm) 730 (W) x 430 (D) x 60 (H)

Installation

This appliance must be installed by trained experts with the technical know- how to check and
determine that:

Table/cabinet for installing the appliance is made of heat resistant materials to avoid the risk
of melting and/or deformations, as well as possible damage to the appliance;
Glue/binder in table/cabinet made of polywood can withstand a temperature of at least 120°
Celsius to avoid the risk of melting and/or deformations, as well as possible damage to the
appliance;
Surrounding walls can withstand all the heat emanating from the appliance when it is in use;
Exact measurements for cutting into the table/cabinet (see diagram) are followed;
Space of at least 50mm wide and 30 mm thick around hole in the table/cabinet is made for
easy installation, and operation of the appliance;
Appliance is not installed in close proximity to other cooking systems, dishwasher or rotary
drying machines; and
There is ≥ 10cm of free space to prevent overheating.

KA WARRANTY PAGE

WARRANTY CARD

WARRANTY CONDITIONS
‘Subject to following Term & Conditions, this equipment is guaranteed against defective material & manufacturing defects by
Flamma Trading Sdn Bhd for a period of elghteen(18) months from the date of origirialpurchase Fiamma Trading Sdn Bad
reserves the right to change these terms & conditions without prior notice.

Terms & Conditions:

This warranty is valid & provided that warranty card is completed with authorized dealer’s stamp from the date of original purchase
and in the territory of Malaysia only.
This warranty covers repair or, a the option of Fame Trading Sdn Bhd, replacement of any pats proven tobe defective due to defective
Workmanship or material provided that the product was purchased from an authorized dealer of Fiamma Trading Sdn Bhd.
This warranty does not cover the damage resulting from:
(a) Any unauthorized disassembly, service repair, alteration or modification being carried out,
(b) Abnormal voltage or the use of generator and or used not in accordance with the Operating Manuel / User] Manuel.
(c) Misuse, abuse, negligence or accident howsoever caused.
(d) This warranty does not cover the following accessories:
(e) Rough handling & transportation.
(f) Commercial / public use e.g, hotel, laundry, colege, university, etc,

(4) Normal wear or tear.
(a) Bumer Caps/Supports (b) Cast ron Grib (c) Knobs (4) Body Work (e) Light Bulb (f) Charcoal /Fiter (a) Cover (h) Glass Cover /
Soreen () Trays/Shelves () Hose

This warranty is considered null & void in the events if
(a) Any item contained in this warranty card has been tempered with or altered in any way without the prior writen consent of
Fiamma Trading Sdn Bhd, Request for warranty services within the warranty period must be accompanied with this warranty card &
proof of original purchase
(b) Any time during the warranty period, any part / parts of this equipment Is / are removed, altered, tempered with, adjusted,
‘modified, dismantled, repaired or handled in any way whatsoever by any person / persons not authorized by us.
(c) The serial number ofthe product has been defaced or removed,
Warranty for WINE CHILLER compressor is (5) five years, gas refll and labor charges are excluded.
In the event of defects covered by this warranty arising during the warranty period, the purchaser shall be fully responsible for the due
delivery to our dedicated service centre of the equipment (expect for the refigerator, washing machine, ovens, cooker hood, gas
‘cooker, dishwasher, dryer, ui hob, freezer, water heater) for any work which shall need to be done pursuant to this warranty &
‘subsequent collection thereof ofthe equipment after the sald work has been done,
This warranty is in hou of any, and all other warranties expressed or implied warranty of merchantabily or fitness for @ particular
purpose. Fiamma Trading Sdn Bhd assumes no liability for the breach of the warranty beyond correcting the breath in the manner
described above, Inno event shall Fiamma Trading Sdn Bhd be liable for consequential losses or damages, including loss of use or
loss of profits resulting from the product.

model name

Customer Care

AFTER-SALES SERVICE
Exact Quality Sdn. Bhd.
Hotline: 03-6286 9000
Email: eqservice@fiamma.com.my

OPERATION HOURS
08:30am = 06:00pm
(Monday – Friday, except public holiday)

Our Warranty

18months
warranty
FOR ALL PRODUCTS
(EXCLUDING ACCESSORIES)

1yrs Warranty | Extensions

Extension
When Register
Online!

Online Registration

Log on to www.rubine.com.my
Click on ‘Support’, followed by ‘Products Warranty
Registration’ to proceed. You’re required to sign up
as a member.
Please fill up the necessary information, tick on the
checkbox and click ‘Nex!
Youll receive a notification of warranty registration
confirmation via email.
Your warranty will be automatically extended for
another 1-year upon registration online, Please
keep your online warranty certificate for reference.