BEGA 33 345 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
33 345 Wall Luminaire
Instruction Manual
Wandleuchte
Wall luminaire Applique
33 345
33 345 Wall Luminaire
Instructions for use
Application
Wall luminaire with light emission on two sides.
Fully glare-free light for illuminating wall surfaces and roadways adjacent to
the walls. For interior and exterior lighting design.
Product description
Luminaire made of aluminum alloy and stainless steel Crystal glass coated
Silicone gasket
2 mounting holes ø 5.5 mm
Distance apart 220 mm
2 cable entries for through-wiring of mains
supply cable ø 7-10.5 mm
Connection terminal 2.5@
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 65
Dust-tight and protection against water jets
Impact strength IK07
Protection against mechanical
impacts < 2 joule
– Safety mark
– Conformity mark
Weight: 4.2 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Lamp
Luminaire with screw base E 27
Lamp output max. 60 W
This product contains light source of energy efficiency class E
Supplied lamp
BEGA LED lamp 13 584
LED Retrofit 7 W · 805 lm · 3000 K
Luminaire efficiency: 42%
Additional BEGA LED lamps are available for this luminaire:
13 586 LED 7 W · 805 lm · 3000 K dimmable
13 588 LED 8 W · 1055 lm · 3000 K
Radio-controlled version (ZigBee 3.0):
13 555 LED 9 W · 805 lm · 2700 K dimmable
13 556 LED 9 W · 805 lm · 2700 – 6500 K dimmable · tunable white
13 557 LED 9.5 W · 805 lm · 2700 – 6500 K dimmable · tunable white · RGBW
Detailed technical and lighting data for the lamps can be found in the data
sheets on our website.
Installation
Undo screws. Remove luminaire cover and glass.
Lead the mains supply cable through the cable entry into the luminaire back
housing.
Note position of application of the luminaire “arrow down”.
Fix luminaire base with enclosed or any other suitable fixing material onto
the mounting surface.
Be sure to use the gasket rings supplied.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamps.
Make sure that gasket is positioned correctly.
Put the luminaire cover and the glass onto the luminaire back housing and
tighten the screws evenly.
Revamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary.
Close the luminaire.
For cleaning, do not use high pressure cleaners.
Spares
| Spare glass | 11 002 767 11 |
|---|---|
| LED lamp 3000K | 13 584 |
| Lamp holder | 63 000 187 |
| Gasket | 83 001 222 |
BEGA Gantenbrink-Leuchten KG
· Postfach 31 60 · 58689 Menden
· info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>