OPTONICA 2835 Running Water Strip User Manual
- June 12, 2024
- OPTONICA
Table of Contents
OPTONICA 2835 Running Water Strip
Product Information
The Running Water Strip is a luminaire that provides decorative lighting
effects. It is designed to be installed and connected with a power supply and
controller to create various lighting modes.
Check Points
- Before installation, carefully inspect the luminaire to ensure there are no defects or damage.
- Make sure to turn off the power before proceeding with the wiring and installation.
How to Choose a Power Supply
Follow these tips to select an appropriate power supply for the Running
Water Strip.
How to Connect Strip with Power Supply and Controller
Use the following steps to connect the strip to a power supply and controller:
- If there is a connector on the strip, cut it off.
- Connect the strip to the amplifier, ensuring the correct wire connections.
- Connect the controller to the amplifier.
- Connect the power adapter to the amplifier.
- Power on the system and enjoy the lighting effects.
Importer
The Running Water Strip is imported by Prima Group 2004 LTD located in
Bulgaria. For any queries, contact them at:
Importe r: Prima Group 2004 LTD
Address: 1784 Sofia, Mladost 1, bl. 144, Ground Floor Phone: +359 2 988 45 72
CHECKPOINTS
- Please check the luminaire carefully before the installation.
- Ensure the power is off before wiring and installation.
HOW TO CHOOSE A POWER SUPPLY: TIPS
- Please be kindly informed that the total wattage of LED strip lights should not exceed the max wattage of the adapter you chose.
- All the adapters mentioned in this User Guide have only one DC output terminal. Thus they can only be used for one single strip light or a strip connected in series.
- To guarantee the lighting uniformity of both the front and the end of the strip light, please do not connect the led strip light more than 10m.
- If you want to use several strip lights together, please connect them in parallel and choose another adapter with more than one output terminal.
HOW TO CONNECT THE STRIP TO THE POWER SUPPLY AND CONTROLLER
HOW TO CONNECT MANY PIECE STRIP CHANGE MODE AT SAME STEP
Connect the strip to the amplifier ( please make sure to connect with the correct wire, if there is the connector on the strip, just cut off the connector), connect the controller to the amplifier, and connect the power adapter to the amplifier. Power on and enjoy it.
IMPORTER: Prima Group 2004 LTD, Bulgaria, 1784 Sofia, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>