VIMAR 30298.x USB Power Supply Instruction Manual
- June 12, 2024
- VIMAR
Table of Contents
VIMAR 30298.x USB Power Supply Instruction Manual
Read the instructions before installation and/or us
Power Delivery technology
VISTA FRONTALE E POSTERIORE
FRONT AND REAR VIEWVUES DE FACE ET ARRIÈRE
Type C USB port 
N.B. Graphic representation of the Linea series. Position of terminals,
wiring and functions also identical for Nikon, Ark and Plana.
FEATURES
Power supply
Alimentation| 120-240 V- 50/60 Hz3.13.6 60 / 50 –c..1.13i 240-120
---|---
Power consumption| 550 rnA – 120 V-
350 mA – 240 V—..’.1.13e 120 ,33.I X1.550 -‘-J39 240 334 v11.4 350
Output power| 30 w • 1,13 30
Power with no load 11| 0.02 W • .619o.oz
Protection degree ko.4.–.11 Zen| IP20
Over/Under Voltage Protection, Over Current Protection, Short Circuit
Protection, Over Temperature Protection (reversible auto-off) contra sur/sous
voltage court-circuit, Protection sur-temperature (auto-off reversible)
Over/Under Voltage Protection, Over Current Protection, Short Circuit
Protection,
Operating temperature : 115119 ZIR.3| 0 °C +35 °Cuse inferno • indoor use
Xp11011(y.13-1111 f IS…..90 C 35 – 0
Device in class II 4310 U1,3|
CAT III Installation for CAT III overvoltage category AD -4
JI alai ,.S,11-1I
DC output current/voltage (± 5%) ES1 and efficiency.
Voltage Tension| Courant Strom| Average efficiency in active mode|
Efficiency with low load (10%)
---|---|---|---
V 5| A 3| 85,9| 84,6
V 9| A 3| 88,6| 85,8
V 12| A 2,5| 89,1| 84,9
V 15| A 2| 89,5| 83,7
V 20| A 1,5| 88,8| 80,3
INSTALLATION RULES
The device can be installed in a flush mounting box or surface mounting box and completed with Linea, Eakin, Ark, or Plana cover plates in dust-free places, protected from accidental impacts and away from heat sources.
IMPORTANT
- An easily accessible omni polar disconnection switch with a contact gap of at least 3 mm must be installed upstream from the power supply.
- Install the device at a height of no more than 2 m
- The power supply unit is protected internally against overloads.
- In the event of an overload, the device disables the output after three resetting attempts. If this occurs, disconnect the USB-C cable from the device and remove the cause of the overload before reconnecting the cable.
- An SPD (surge protection device) must be installed upstream from in the system, in order to reduce the overvoltage category from III to II.
REACH (EU) Regulation no. 1907/2006 – Art.33. The product may contain traces of lead.
DEVICE DETAILS AND WEEE INFORMATION CAN BE DOWNLOADED IN PDF FORMAT FROM
THE PRODUCT DATA SHEET ON www.vimar.com (the QR
code opens the data sheet of art. 30298.B, which shares the same instructions
sheet as art.
Tell : 30298.x-20298-19298-14298).
49401775A0 01 2203
Viale Vicenza, 14
36063 Marostica VI – Italy
Ph : 49401775A0 01 2203
Website : www.vimar.com