Jandy TC3 Flush Mount Pool/Spa Return Jet Installation Guide
- June 6, 2024
- Jandy
Table of Contents
Jandy TC3 Flush Mount Pool/Spa Return Jet Installation Guide
TC3 Flush Mount Pool/Spa Return Jet
CAUTION
This product must be installed by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exists.
-
After the 1½” return line is plumbed through shell and pressure tested, cut pipe flush with the pool wall.
-
. Use Inside Pipe Cutter (part #5-17-4) to cut pipe back 5/8″ behind shell surface.
-
Prime pipe and fitting. With protective cap attached, glue fitting into pipe, positioning for thickness of finish material.
-
After troweling the final finish, use needle-nose pliers (or ThreadCare Tool, part #4-17-4) to remove the protective cap turning clockwise until cap separates or breaks off.
- At startup, select and insert the applicable restrictor nozzle if required for the installation.
©2021 Zodiac Pool Systems LLC. All rights reserved. Zodiac® is a registered trademark of Zodiac International, S.A.S.U. used under license. All other trademarks referenced herein are the property of their respective owners. TL-1317 D
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>