COSTWAY HU10041 Twin Bunk Bed with Trundle Drawer User Manual
- September 3, 2022
- COSTWAY
Table of Contents
COSTWAY HU10041 Twin Bunk Bed with Trundle Drawer
Before You Start
- Read each step carefully before starting. It is very important to ensure each step is followed in the correct order, otherwise, assembly difficulties may occur.
- Most of the board parts are labeled or stamped on the raw edges.
- Have a check to make sure all parts are included.
- Work in a spacious area, preferably on a carpet close to where the unit will be used.
- Keep the hand tools close at hand. Do not use power tools to assemble your furniture. They may scratch or damage the parts.
Detail View
Part List
Hardware List
ASSEMBLY TOOLS REQUIRED ( NOT INCLUDED )
PLEASE BE CAREFUL NOT TO DAMAGE THE HOLE POSITION WHEN YOU USE POWER TOOLS!
THE STEPS ARE SHOWN IN THE FOLLOWING:
Note: Part 7 will face up with the “x” mark on it, otherwise it cannot be
tightened
REMEMBER, DO NOT fully tighten screws in steps 2—step 6 until step 6 is
completed.
Note: Do not lock the screws of the bed slats to the outermost edge of the bed slats, you need to leave a certain space at the edges, otherwise it will cause the board to break. Do not lock the bed slats on the edge of the wood, please hold firmly before screwing, hold it in place with one hand, then lock the screw.
Note: Do not lock the screws of the bed slats to the outermost edge of the bed slats, you need to leave a certain space at the edges, otherwise it will cause the board to break. Do not lock the bed slats on the edge of the wood, please hold firmly before screwing, hold it in place with one hand, then lock the screw.
Care and Maintenance
- Use a soft, clean cloth that will not scratch the surface when dusting.
- The use of furniture polish is not necessary.
- Should you choose to use polish, test first in an inconspicuous area.
- Using solvents of any kind on your furniture may damage the finish.
- Never use water to clean your furniture as it may cause damage to the finish.
- Liquid spills should be removed immediately.
- Using a soft clean cloth, blot the spill gently. Avoid rubbing.
- Check bolts/screws periodically and tighten them if necessary.
Further advice about wood furniture care
- It is best to keep your furniture in a climate-controlled environment.
- Extreme temperature and humidity changes can cause fading, warping, shrinking, and splitting of wood.
- It is advised to keep furniture away from direct sunlight as the sun may damage the finish.
- Proper care and cleaning at home will extend the life of your purchase.
- Following these important and helpful tips will enhance your furniture as it ages.
Please give us a chance to make it right and do better!
Contact our friendly customer service department for help first. Replacements
for missing or damaged parts will be shipped ASAP!
- US office: Fontana
- UK office: Ipswich
- AU Office: Truganina
Contact Us
DO NOT RETURN THIS ITEM
Contact our friendly customer service department for help first.
- US: [email protected]
- UK: [email protected]
- AU: [email protected]