BEGA 89 012 Wall Ceiling Light Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
BEGA 89 012 Wall Ceiling Light
Dimension
Instructions for Use
Application
Ceiling and wall luminaire · indoor luminaire made of hand-blown opal glass,
satin matt and metal housing, for all lighting tasks.
They are ideal for places where a soft and uniform lighting distribution is
required.
Luminaire with a high protection class.
Lamp
Luminaire with screw base E 27
Lamp output max. 3 × 75 W
This product contains light sources of energy efficiency class E
Supplied lamp
3 × BEGA LED lamp 13548
LED Retrofit 7 W · 805 lm · 2700 K dimmable
Supplied lamp
3 × BEGA LED lamp 13586
LED Retrofit 7 W · 805 lm · 3000 K dimmable
Luminaire efficiency: 70%
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Product Description
Aluminium alloy housing, finish Colour white
Hand-blown opal glass, satin matt, with sliding-bolt closure 2 mounting holes
ø 5.5mm
Distance apart 280mm 2 cable entries for through-wiring for mains cable up to
ø 10.5 mm max. 3 × 1.5@
Connection terminal 2.5@
Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies
≥ 1 mm and splash water
Impact strength IK06
Protection against mechanical
impacts < 1 joule
Safety mark
Conformity mark
Weight: 3.9 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Installation
Lead mains supply cable through the cable entry into the luminaire housing.
Notice position of application »arrow down« when installed at the wall.
Fix the luminaire housing with enclosed or any other suitable fixing material
onto the mounting surface.
It is imperative to use the enclosed gaskets.
Make earth conductor connection.
Push silicone sleeves over the lines and make electrical connection.
Insert lamps.
Place glass to the luminaire housing and observe that the holding springbolts
fit into the notches of the glass.
Turn the glass clockwise until it is locked.
Thus, you reach a safe and vibration-resistant holding of the glass.
To release the glass from the luminaire housing, turn it counter-clockwise.
Relamping · Maintenance
Disconnect the electrical installation.
To release the glass from the housing, turn it counter-clockwise.
Clean luminaire and glass.
Use only solvent-free cleansers.
Change the lamp.
The sliding-bolt closure provides a safe and vibration-resistant holding of
glass.
Place glass to the housing and observe that the holding spring bolts fit into
the notches of the glass.
Turn the glass clockwise until it is locked.
Spares
Spare glass 11 002 126 .0RG
LED lamp 2700 K 13 548
LED lamp 3000 K 13 586
Lampholder 63 000 052
Customer Support
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com