SEVERIN AS 3915 Universal Cutter Instruction Manual
- June 12, 2024
- SEVERIN
Table of Contents
ART.-NO. AS
3915
AS 3915 Universal Cutter
Multi-use slicer
Dear Customer,
Before using the appliance, read the following instructions carefully and keep
this manual for future reference. The appliance must only be used by persons
familiar with these instructions.
Connection to the mains supply
The appliance should only be connected to an earthed socket installed in
accordance with the regulations. Make sure that the supply voltage corresponds
with the voltage marked on the rating label of the appliance. This product
complies with all binding CE labelling directives.
Familiarisation
- On/Off switch
- Thickness selection knob
- Ham-cutting blade
- Serrated blade
- Central locking screw
- Sliding tray
- Power cord with plug
- End-piece holder with finger guard
- Stop plate
- Rating label (on underside of the unit)
Important safety instructions
-
In order to avoid hazards, repairs to this electrical appliance or its power cord must be carried out by our customer service. If repairs are needed, please send the appliance to our customer service department (see appendix).
-
Before cleaning the appliance, ensure it is disconnected from the power supply and has cooled down completely.
-
To avoid the risk of electric shock, do not clean the appliance with water and do not immerse it in water.
-
The appliance must be cleaned regularly. For more detailed information, please refer to the section Cleaning and care.
-
We strongly recommend that the appliance is only used with the sliding tray and end-piece holder properly installed and in position. Exceptions may be made only if required by the size or shape of the food to be sliced.
-
Warning! Misuse of the device can cause injuries!
-
Warning! The cutting blade is sharp. Risk of injury!
-
Always remove the plug from the wall socket – when there is no supervision, – before any assembly or disassembly, – after use, – in case of any malfunction, – during cleaning of the appliance.
-
This appliance is intended for domestic or similar applications, such as – in kitchens for employees, in shops, offices and similar working environments, – in agricultural working environments, – by customers in hotels, motels etc. and similar establishments, – in bed-and breakfast type environments.
-
The appliance may only be used by persons with reduced physical, sensory or mental capabilities, or lacking experience and knowledge, if they have been given supervision or instruction concerning the use of the appliance and fully understand all dangers
and safety precautions involved. -
Children must not be permitted to operate the appliance.
-
The appliance and its power cord must be kept well away from children.
-
Children must not be permitted to play with the appliance.
-
Caution: Keep any packaging materials well away from children – these materials are a potential source of danger, e.g. of suffocation.
-
Every time the appliance is used, the main body including the power cord as well as any attachment fitted should be checked thoroughly for any defects. Should the appliance, for instance, have been dropped onto a hard surface, or if excessive force has been used to pull the power cord, it must no longer be used: even invisible damage may have adverse effects on the operational safety of the appliance.
-
Do not allow the slicer to come into contact with open flames or any hot surface such as hotplates.
-
Do not operate the slicer unless the sliding tray is in its correct operating position.
-
Do not allow the power cord to come into contact with the blade.
-
When removing the plug from the wall socket, never pull on the power cord.
-
This appliance should only be used with the original attachments provided with this appliance or by the manufacturer.
-
Caution: Do not touch the blade during operation, and do not try to stop it
-
No responsibility is accepted if damage results from improper use, or if these instructions are not complied with.
Before using this appliance for the first time
Clean the slicer before using it for the first time, or after a long period of
non-use.
Applications
The slicer is designed for use with bread, cooked meats, ham, cheese, cold
roasts and other food suitable for slicing.
Serrated blade
The serrated blade is useful for slicing bread.
Ham-cutting blade
The ham-cutting blade is helpful when slicing ham, cheese etc.
Changing the blades
Caution: Always disconnect the appliance from the mains before changing the
blades.
To detach the blade, turn the central locking screw of the blade 90° in a
clockwise direction and take it off. After re-fitting the blade, turn the
locking screw 90° anti- clockwise to lock it.
Operation
Short-term operation
The appliance has been designed for shortterm operation only, i.e. the slicer
should not be operated continuously for more than 10 minutes. Switch it off
afterwards and allow the motor to cool down before switching on again
Positioning the slicer
- Position the slicer on a flat, stable surface.
- Before the appliance is connected to the mains, ensure that the On/Off switch is in the Off-position.
Slicing
- Use the thickness selection knob to adjust the desired thickness of the slices.
- Place the food to be sliced onto the sliding tray and press it against the stop plate.
- Fit the safety holder, with the studded side facing the blade, onto the sliding tray.
- Switch the appliance on and move the sliding tray towards the rotating blade. At the same time, lightly press the endpiece holder with the food towards the blade.
- The end-piece holder ensures safe handling of the food while slicing.
- When removing the sliced food, keep fingers and hands well away from the blade, which is extremely sharp.
- Always switch the slicer off after use.
- For safety reasons, always bring the stop plate back to its rest position after use so that it is flush with the blade.
Practical hints
- When cutting a loaf of bread where the crust is thicker or harder on one side, it should be placed against the blade in such a way that the firm side faces the blade.
- When cutting ham, ensure that the fatty side is facing upwards.
Cleaning and care
General
- To prevent perishable food particles from collecting in the slicer, clean it thoroughly after use.
- Always remove the plug from the wall socket before cleaning the slicer.
- Wait until the motor has come to a complete standstill. Bring the stop plate to its rest position so that the blade does not protrude.
- To avoid the risk of electric shock, do not clean the appliance with water and do not immerse it in liquid of any kind.
- Do not use abrasives or harsh cleaning solutions.
- The sliding tray can be folded out for easy access when cleaning the appliance.
- To clean the sliding tray, a damp, lintfree cloth and a mild detergent should be used.
- If necessary, the housing may be wiped with a slightly damp, lint-free cloth.
- The safety holder can be cleaned using hot water and a mild detergent (do not put in a dish-washer).
Detaching and cleaning the blade
- Caution: The blade is extremely sharp, risk of injury.
- The stainless-steel blade can be cleaned with a slightly damp, lint-free cloth.
- The area behind the blade should also be cleaned occasionally, using a slightly damp cloth. To detach the blade, turn the central locking screw of the blade 90° in a clockwise direction.
- After re-fitting the blade, turn the locking screw 90° anti- clockwise to lock it.
Information for testing institutes
Operate the device with frozen ham (-15°C).
Disposal
Devices marked with this symbol must be disposed of separately from your
household waste, as they contain valuable materials which can be recycled.
Proper disposal protects the environment and human health. Your local
authority or retailer can provide information on the matter.
Model specifications are subject to change.
I/M No.: 10195.0000 09/22
SEVERIN Elektrogeräte GmbH
Röhre 27
D-59846 Sundern
Tel +49 2933 982-0
Fax +49 2933 982-1333
[email protected]
www.severin.com
Documents / Resources
|
SEVERIN AS 3915 Universal
Cutter
[pdf] Instruction Manual
SEVERIN, Product Name Universal cutter, AS 3915, AS 3915 Universal Cutter,
Universal Cutter, Cutter
---|---