Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler Instruction Manual

June 4, 2024
KingFisher

GHFSWC25BUK Black glass bottles Drinks cooler
Instruction Manual

Kingfisher GHFSWC25BUK Black glass bottles Drinks
cooler

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
1

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
2

IMPORTANT – Please read carefully the separate safety guide before use.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
3

Product Description

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
4

1. Hinge cover 6. Bottom hinge
2. Shelves 7. Small adjustable foot
3. Storage rack 8. Door
4. Securing bolt 9. Top hinge and cover
5. Large adjustable foot 10. Controls (not visible)

Installation

01

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
5

Positioning the appliance
This appliance should be installed underneath the worktop between two base cabinets or at the end of a row.

  • Ensure the appliance is installed directly onto a flat even floor.
  • Do not mount into a base cabinet or on top of any other furniture.
  • Remove all packaging before use and dispose of it responsibly.
  • Do not use it outdoors or in a wet location.
  • Do not locate the appliance in direct sunshine or near heat sources.
  • Do not tilt the appliance by more than 45° during installation.
  • This appliance is designed to be operated between ambient temperatures of 10°C and 32°C under climate classes Sub-Normal (SN) and Normal (N).
  • Do not install in a garage or outhouse where the ambient temperatures may exceed this range.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
6

Level adjustment and adjusting the feet

  • There is a small range of adjustments at the front to level the appliance.
  • Carefully adjust both feet to ensure the appliance is not tilted and unstable.
  • Use a spirit level to ensure the appliance is perfectly flat in all directions.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
7

Changing The Door
This appliance has the door factory fitted on the right side of the carcass.
To change the fitting to the left side, proceed as follows.

  • Tilt the appliance back slightly to gain access to the bottom hinge bracket.
    Do not exceed 45° and ensure it does not fall.

  • Open the door to 90°.

  • Remove the four bolts at the appliance’s bottom to release the bottom hinge.

  • Detach the door from the top hinge. Place the door on a soft surface to avoid scratching the glass.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
8

  • Unscrew the large foot and securing bolt from the left underside of the carcass.
  • Attach the bottom hinge with the four bolts from step 03.
  • Replace the large foot and securing bolt to the right underside of the carcass.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
9

  • With a flat blade screwdriver, carefully prise off the plastic hinge cover from the top hinge.
  • Repeat this with the hinge cover on the left side.
    TAKE EXTRA CAUTION TO AVOID SCRATCHING THE SURFACE!

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
10

  • Remove the four bolts and top hinge from the right side.
  • Remove the hole plug from the left side of the door and replace it on the right side along with the hinge cover.
  • Align the bottom of the door onto the bottom hinge.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
11

  • Engage the top hinge into the hole in the door.
  • Secure the hinge to the top of the carcass with the four bolts.
  • Replace the hinge cover.
    CAUTION: Ensure the door is completely aligned with the edges of the carcass before securing the bolts to ensure the door seal operates correctly.

Use

First use

Cleaning the appliance

  • Before using the appliance for the first time, clean the inside with warm soapy water and a well-wrung damp cloth.

  • Refer to the Care and Maintenance section at the end of this manual for further information.
    Locating the appliance

  • This appliance is for freestanding use only and should be sited between, or at the end of, a run of kitchen cabinets. Do not build it into a kitchen cabinet.

  • Once the appliance is installed and leveled in its final location, allow at least thirty minutes before switching on the main power. This is to allow the refrigerant to settle before use.
    Switching on the appliance

  • Turn on the mains power and the compressor will start to work.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
12

Control elements

LED light switch • Set to “I” for on and “O” for off.
Thermostat dial • Set the thermostat to 1 for the highest temperature, and 7

for the lowest temperature.
• Set the thermostat to 0 to turn off the appliance.

IMPORTANT: If the door is left open for one minute, a warning alarm will sound; please close the door promptly.

Capacity

  • Each shelf has a capacity of four bottles when configured as shown.
  • The bottom compartment has a capacity of four bottles when configured as shown.
    (Based on a standard Bordeaux bottle size of 750 ml.)

IMPORTANT: This configuration will alter significantly dependent upon the size and shape of the bottles in use. Ensure that all shelves operate freely and the door closes completely to ensure the correct operation of the appliance.

IMPORTANT: Do not use bottles that protrude from the opening to avoid damaging the door glass when closing.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
13

Care and Maintenance

Cleaning

  • Disconnect the appliance from the power supply before cleaning.
  • Remove the shelves as shown.
  • Clean the cavity with a well-wrung cloth and warm soapy water.
  • Do not use abrasives, solvents, or acid or alkaline cleaners.

Kingfisher GHFSWC25BUK Black glass bottles Drinks cooler - Figurre
14

Moving the appliance

  • If the appliance will not be used for a long period, ensure that it is clean and dry and the door is left ajar to prevent the development of mold.
  • Before moving, unplug from the power supply, remove all bottles, and do not tilt greater than 45°.
  • Allow at least thirty minutes before turning the appliance back on.

Safety

WARNING: This appliance is designed for the storage of beverages only.
Do not store food or any other material in this appliance.

Availability of Spare Parts

Dependent upon the spare part, these are available for a minimum period of seven years for professional repairers or a minimum of ten years for professional repairers and end- users. Contact the Customer Service helpline for assistance or visit:
www.kingfisherspares.com
For assistance, contact the Customer Services helpline:
UK 0800 324 7818 uk@kingfisherservice.com
Eire 1-800 932 230 eire@kingfisherservice.com
Further information about this appliance can also be found at:
www.kingfisher.com/products

Addresses

www.diy.com
www.screwfix.com
www.screwfix.ie
Customer Helpline (Freephone)
UK 0800 324 7818 uk@kingfisherservice.com
Eire 1800 932 230 eire@kingfisherservice.com
To view instruction manuals online,
visit www.kingfisher.com/products

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals