LARK 83533 Pippa LED Flush Mount Instruction Manual
- June 12, 2024
- LARK
Table of Contents
Assembly Instructions
Item No: 83533
83533 Pippa LED Flush Mount
start here
| DRAWING 1 – MOUNTING | DRAWING 2- GLASS INSTALLATION |
|---|---|
-
Find a clear area in which you can work.
-
Unpack fixture and glass from carton.
-
Carefully review instructions prior to assembly.
-
To begin installation first release mounting plate (A) — from canopy (B) by removing the t wo canopy screws (C).
-
Next secure mounting plate (A) to junction box (J) using 2 screws (D) not provided.
-
Make electrical connections using IS-18 provided
-
Tuck in electrical wires and secure canopy (B) to mounting plate (A) using the previously removed screws (C)
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUC-TIONS (IS18) AND ANY
ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING INSTALLATION. IF NEW
WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR
CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet (IS 18) and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to complete installation of
this fixture.
- To install glass (1) first remove the threaded socket cover (2) and steel cover (3) from socket (S) – See Drawing 2.
- Next slip glass (1) over socket and hold in position.
- Now slip spacer (3) over socked. Now thread on socket ring (2) and tighten till snug to secure glass.
LARK 33000 PIN OAK PARKWAY, AVON LAKE, OH 44012
LarkLiving.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>