BEGA 51 030.6 Table Lamp Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
Technical amendments reserved
51 030.6
Table lamp for indoor use
Instructions for use
51 030.6 Table Lamp
Application
Table lamp· indoor luminaire with metal housing and light-diffusing synthetic disks for shielded light, deflected upwards and downwards.
Product description
Table lamp »STUDIO LINE« Metal housing, finish Colour velvet black Aluminium
housing shield, Finish Colour velvet black inside hue matt copper Light-
diffusing synthetic disks with optical texture Touch-controlled dimmer for
infinite light adjustment Black cable · 2 m, with safety plug LED power supply
unit 220-240 V 50-60 Hz BEGA Thermal Switch® Temporary thermal shutdown
to protect temperature-sensitive components Safety class I
– Conformity mark
Weight: 2.6 kg
This product contains light sources of energy efficiency classes D
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we
recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp
Module connected wattage| 17.1 W
Luminaire connected wattage| 19.5 W
Rated temperature| ta = 25 °C
Ambient temperature| ta max = 25 °C
51 030.6 K3
Module designation| LED-1224/930 + LED-1225/930
Colour temperature| 3000 K
Colour rendering index| CRI > 90
Module luminous flux| 2820 lm
Luminaire luminous flux| 1297 lm
Luminaire luminous efficiency| 66,5 lm / W
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or revamping.
Carefully remove the table lamp from its packaging and set it up. Make sure
that the luminaire is in a firm and secure position.
Guide the housing
shield provided over the luminaire’s light-diffusing synthetic lenses and into
its end position.
Connect luminaire to mains supply (230 V).
The luminaire is equipped with a touch controlled dimmer in the middle of the
upper light-diffusing lens.
Press sensing device gently to turn the luminaire on or off.
Holding the sensing device enables to adjust the light intensity infinitely.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
We recommend that you dry-clean the sensing device.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted. The module can be replaced by
qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective luminaire cover must be replaced. Close the luminaire.
Spares
LED power supply unit| DEV-0402/520
LED module 3000 K down| LED-1224/930
LED module 3000 K top| LED-1225/930
Housing shield| 71 003 492 B4
BEGA Gantenbrink-Leuchten KG
Postfach 31 60 58689 Menden
info@bega.com
www.bega.com
Documents / Resources
| BEGA
51 030.6 Table
Lamp
[pdf] Instruction Manual
51 030.6 Table Lamp, 51 030.6, Table Lamp, Lamp
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>