BEGA 51203.1 LED Pendant Luminaire Instruction Manual

: June 12, 2024
: BEGA

Table of Contents

BEGA 51203.1 LED Pendant Luminaire
DIMENSIONS
Instructions for use
Product Description
Safety
Installation
Cleaning · Maintenance
Accessories
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

BEGA 51203.1 LED Pendant Luminaire

DIMENSIONS

BEGA-51203-1-LED-Pendant-Luminaire-FIG-1

Instructions for use

Application

Pendant luminaire downlight · indoor luminaire with wide beam light distribution.
BEGA Hybrid Optics®: Highly efficient and low loss light distribution, thanks to reflector and optical lens.
BEGA System pendant luminaire for use in combination with various modular BEGA installation components.

Product Description

Pendant luminaire downlight
Cast aluminum luminaire housing, finish Colour velvet white,
The reflector surface is made of pure aluminum
Optical silicone lens · BEGA Hybrid Optics®
Trim ring · Chrome finish
Clear safety glass
Cable pendant · Sheath cable white 2 x 0,5@
The overall length of the luminaire is approx. 1500 mm
Safety Class III
– Conformity mark
Weight: 0.75 kg
This product contains light sources of energy efficiency class(es) F
Luminaire without canopy,
for connection to an additional required
BEGA Installation component (accessory)

Lamp

Module connected wattage 11.1 W
Luminaire connected wattage 14 W
Rated temperature ta = 25 °C
Ambient temperature ta max = 40 °C

51 203.1 K3

Module designation LED-1150/930
Color temperature 3000 K
Color rendering index CRI > 90
Module luminous flux 1305 lm
Luminaire luminous flux 1120 lm
Luminaire luminous efficiency 80 lm / W

Lighting technology

Half beam angle 37°

Safety

The installation and operation of this luminaire are subject to national safety regulations.
Installation and commissioning may only be carried out by a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or installation.
If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.

Please note
The luminaire can only be operated with an operating device that fulfills the requirements according to EN 61347-2-13. The maximum idle voltage of 60 V DC must conform to SELV or SELV equivalent.

Installation

LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or relamping. Screw enclosed trim ring with attached reflector into the luminaire housing by turning it clockwise. To operate this luminaire one of the following additional BEGA Installation components must be ordered – accessories. Please refer to the instructions for use for the BEGA installation component selected for luminaire installation.

Please note
The manufacturer accepts no liability for damage caused by improper use or installation if no BEGA installation component is used to install this BEGA system pendant luminaire.

Cleaning · Maintenance

Clean the luminaire regularly with solvent-free cleansers from dirt.

Replacing the LED module
The designation of the LED module is noted on a label in the luminaire. The light color and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by a qualified person using commercially available tools. Disconnect the system and open the luminaire. Please follow the installation instructions for the LED module. Close the luminaire.

Accessories

BEGA Installation components with LED power supply unit. Satin white finish. Depending on the desired type of installation, the following suitable installation components are available for this BEGA system pendant luminaire: For all level ceilings:

13 229 Surface-mounted canopy (Type A) on/off · 220-240 V · 350 mA DC
13 282 Surface-mounted canopy (Type AS) Smart controllable/dimmable · 220-240 V · 340 mA DC Suitable for level ceilings and sloped ceilings with a pitch of 0 – 40°:
13 232 Surface-mounted canopies (Type B) on/off · 220-240 V · 350 mA DC 13 235 Recessed canopies (Type C) on/off · 220-240 V · 350 mA DC 13 285 Recessed canopies (Type CS) Smart controllable/dimmable · 220-240 V · 350 mA DC For flush and surface-mounted 3-phase Eurostandard-Plus® track systems:
13 220 Track adapter (Type D) on/off · 220-240 V · 350 mA DC

For the accessories, separate instructions for use can be provided upon request.

Spares