LITETRONICS LHBC Series LED Linear High Bay Installation Guide
- June 12, 2024
- Litetronics
Table of Contents
LED Linear High Bay (C-Series)
Installation Instructions
Ordering Code: LHBC Series
LHBC Series LED Linear High Bay
WHAT COMES IN THE BOX
LED Linear High Bay with 6’ input wire
2 V-hooks and chains
Installation instructions
TOOLS NEEDED
Wire Stripper
Wire Cutter
Phillips Screwdriver
SAFETY INSTRUCTIONS AND WARNINGS
WHEN USING ELECTRICAL EQUIPMENT, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
- Risk of fire or electric shock. Linear High Bay or Low Bay luminaire installation requires knowledge of luminaires electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician.
- Be certain electrical power is OFF before and during installation and maintenance.
- Linear High Bay or Low Bay luminaire must be connected to a wiring system with an equipment – grounding conductor.
- Make sure the supply voltage is same as the rated luminaire voltage
- Only those open holes indicated in the photographs and/or drawings may be made or altered as a result of this fixture installation. Do not leave any other open holes in an enclosure of wiring or electrical components.
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or sharp objects.
- No user serviceable parts inside of Linear High Bay or Low Bay Lumiaire.
Before starting installation, turn off power at circuit breaker.
SETTING THE COLOR TEMPERATURE
1. Before installing the fixture, find the CCT slide switch on the side of
the driver and select the preferred color temperature.
CCT settings: 4000K | 5000K
SUSPENDING THE FIXTURE FROM A BEAM/RAFTER (FIGURE A)
- Suspend the fixture by securing the v-hooks to the interior structure.
- Install the chains to the provided v-hooks, then mount the hangers to the top side of the fixture (as shown in Figure A).
- Make wiring connections based on the instructions and diagrams below.
INSTALLING THE PLUGGABLE SENSOR (FIGURE B)
- Unscrew and remove sensor port plug
- Plug sensor into port and screw to tighten (sensor sold separately)
WIRING DIAGRAM
120V & 277V
*For 240V, follow 480V wiring instructions
FIGURE A – FIXTURE INSTALLATION
FIGURE B – SENSOR INSTALLATION
Thank you for choosing
6969 W. 73rd Street
Bedford Park, IL 60638
WWW.LITETRONICS.COM
[email protected] or
1-800-860-3392
The information and product specifications contained in these instructions are
based upon data believed to be accurate at the time of printing. This
information is subject to change without notice and without incurring
liability. If you have questions regarding specific product details, please
contact us at 800-860-3392 or via email
at [email protected].
To check for an updated version of these instructions, please visit
www.litetronics.com.
7/14/22 – V1.2