Untitled KYP1300 Alarm Keypad User Guide

Table of Contents

Product Name: Alarm Keypad
Model No.: KYP1300

Included Items:

Requirements:

Features:

Green LED: Normal on when power is on
Blue LED: Flashes once for Arm/Stay or Disarm
Red LED: Flashes once for wrong programming, every 3 seconds for low battery indication
Wake Up Key, Arm, Arm in Stay Mode, Disarm, SOS Key, Battery Slot
Wired Cables Interface, Tamper Switch, Screw Hole, Rear Cover

Broadband internet connection, iOS or Android phone and home router required.

Step 1: Assemble your device and accessories

Unpack your device and accessories.
Pair the device with the Security Shuttle within 1-10 feet to ensure a working connection.
Pull and remove the plastic strip to initiate the battery contact.

Step 2: Add a device

Open the app and tap on the menu button then select Device Management.
Press the add button next to Sensor List.
Follow the app instructions to scan the QR code located on the device. If the scan is incomplete, enter the serial number (SN) of the device.

Step 3: Mount your device
Before mounting, ensure your device is within Security Shuttle’s range.

Take your device to the desired room.
Press then SOS for 3 seconds. If you receive a notification saying “Emergency,” you are within range.

To activate the keypad, enter the admin password # or user password # before operating.

Arm: Press 1234 #
Arm in Stay: Press 1234 #
Disarm: Press 1234 #
Mute: Press # , then press within 1 second to enter Siren Delay – No Siren – Exclude Emergency Events mode.
Unmute: Press # , then press within 1 second to cancel Siren Delay mode.
SOS: Press SOS for 3 seconds to activate an immediate Emergency Call alarm.

Press “ ***** ” to activate keypad then enter admin password # or user password # before operating.

Note: If there is no operations within 5 seconds after pressing ” “, keypad will exit setup state automatically.

To enter the setting state, press then enter admin password # 9. Blue LED will light up. Then insert your command.

Note: No operation within 30 seconds, keypad will automatically exit setup state.

If your devices are not listed in the app, follow the instructions to add any missing devices.

Are your devices listed in your app?
If you’re having trouble installing your devices, see if they’re listed in your app:

Navigate to Device Management to see if all your devices are listed.
Tap + next to the device category and follow the on-screen instructions to add any missing devices. Are your devices communicating with Security Shuttle?
If your devices don’t connect to Security Shuttle, they might be too far away. Take them to a location that’s closer to Security Shuttle and try again.
If they do connect, you’ll know the range of your device and where to install a range extender.
Alternatively, you can move Security Shuttle closer to your device.
If your devices still don’t communicate with Security Shuttle, even when they’re in the same room, navigate to > Device Management > + on the app to add your devices again.

Reset to Default Settings
Press the Tamper Switch 5 times in a row, then you will heard one long beep.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modiﬁcations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.