HYTRONIK HBIR29-2CH PIR Standalone Motion Sensor Instruction Manual
- June 12, 2024
- HYTRONIK
Table of Contents
HYTRONIK HBIR29-2CH PIR Standalone Motion Sensor Instruction Manual
PIR Standalone Motion Sensor with 5.0 SIG Mesh
HBIR29/2CH
Low-bay
HBIR29/2CH/R
Reinforced Low-bay
HBIR29/2CH/W
Wide range Low-bay
HBIR29/2CH/H
High-bay
HBIR29/2CH/RH
Reinforced High-bay
Product Description
HBIR29/2CH is Bluetooth PIR standalone motion sensors with two independent channel outputs. One is DALI channel output (50mA DALI power supply built in), which can control up to 25 LED drivers. The other is voltage-free contact, which is NC (normally closed contact). It is ideal for typical indoor applications such as ofce, classroom, healthcare and other commercial areas. With Bluetooth wireless mesh networking, it makes communication between luminaires much easier without time-consuming hardwiring, which eventually saves costs for projects (especially for retrot upgrade projects!). Meanwhile, simple device setup and commissioning can be done via app.
App Features
Hardware Features
Technical Specifications
- For more details of detection range, please refer to “detection pattern” section.
Placement Guide and Typical Range for HBIR29/2CH/H & HBIR29/2CH/RH
Smart Phone to Device Range
The smart device with the App installed will have a typical range of 10m, but varies from device to device. During commissioning, the installer will need to be in range of the devices when searching for devices to add to the network.
Once the devices have been added to the network via the App, the devices will start communicating within the wireless mesh. This means that once the network is complete, all devices are accessible from the smart device when in a 20m range of a single point.
Mechanical Structure & Dimensions
- Ceiling (drill hole Ø 66~68mm)
- Carefully prise off the cable clamps.
- Make connections to the pluggable terminal blocks.
- Insert plug connectors and secure using the provided cable clamps, then clip terminal covers to the base.
- Fit detection blind (if required) and desired lens.
- Clip fascia to body.
- Bend back springs and insert into ceiling.
Wire Preparation
Pluggable screw terminal. It is recommended to make connections to the terminal before fitting to the sensor.
Big and small silicon gasket used to make IP54 degree protection when HBIR29/2CH series device mounted into HA03 housing for ceiling mount
Detection Pattern & Optional Accessories
Wiring Diagram
Dimming Interface Operation Notes
Switch-Dim
The provided Switch-Dim interface allows for a simple dimming method using
commercially available non-latching (momentary) wall switches.
Detailed Push switch configurations can be set on Koolmesh app.
Additional Information / Documents
- To learn more about detailed product features/funcvtions, please refer to www.hytronik.com/download ->knowledge ->Introduction of App Scenes and Product Functions
- Regarding precautions for Bluetooth product installation and operation, please kindly refer to www.hytronik.com/download ->knowledge ->Bluetooth Products – Precautions for Product Installation and Operation
- Regarding precautions for PIR Sensors installation and operation, please kindly refer to www.hytronik.com/download ->knowledge ->PIR Sensors – Precautions for Product Installation and Operation
- Data sheet is subject to change without notice. Please always refer to the most recent release on www.hytronik.com/products/bluetooth technology ->Bluetooth Sensors
- Regarding Hytronik standard guarantee policy, please refer to www.hytronik.com/download ->knowledge ->Hytronik Standard Guarantee Policy
Subject to change without notice.
Edition: 19 Apri. 2022
Ver. A0
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>