OPTONICA OP5927 LED SMD Floodlight Instruction Manual

: June 12, 2024
: OPTONICA

Table of Contents

OPTONICA OP5927 LED SMD Floodlight
Product Information
Product Usage Instructions
LED FLOODLIGHT
MOUNTING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

OPTONICA OP5927 LED SMD Floodlight

Product Information

Product Name: 10W-70W
Size: 285x210mm
Importer: Prima Group 2004 LTD
Location: Bulgaria, 1784 Sofia, Mladost 1, bl. 144, Ground Floor
Contact Phone: +359 2 988 45 72

Product Usage Instructions

Ensure the product is placed on a stable surface.
Connect the product to a power source using the appropriate power cable.
Turn on the power switch located on the product.
Adjust the power output according to your requirements using the provided controls.
To turn off the product, simply switch off the power switch.
Do not exceed the recommended wattage range (10W-70W) to avoid damage to the product.
Keep the product away from water and other liquids to prevent electrical hazards.
Regularly clean the product using a soft cloth to remove dust and debris.
If you encounter any issues or have questions, refer to the user manual or contact the importer at +359 2 988 45 72.

LED FLOODLIGHT

Specifications and Technical Data:

Luminaire Category: LED Floodlight
Input voltage: AC220-240V 50HZ/60HZ
Ambient Temperature: -40°C <TA<50°C

WARNING:

ENSURE ELECTRICITY IS SWITCHED OFF BEFORE YOU INITIATE ANY MANIPULATIONS.
Please read carefully the following instructions before commencing installation.
Some of the necessary accessories and spare parts may not be provided including the junction box.
The Floodlight must be earthed.
If the safety shield is damaged, you must replace it immediately, with tempered glass.
This is a professional-use product, any installation and/or service must be undertaken by a qualified person. Serious injury or death may occur if otherwise.

MOUNTING

Do not install this product to an unstable surface or any such vibrating one.
Remove the screw intended for mounting the bracket of the fixture. Remove the bracket.(see fig.2)
Mark the hole position for fixing the bracket onto the wall. Drill the wall at the marked positions (screw not supplied). (see fig.3)
Screw the fixing bracket to the wall with a suitable screw (see fig.4)
Mount the bracket back to the fixture. Adjust the floodlight to desired position and tighten the screw of fixing bracket. Connect the mains cable (H05RN-F3G1.0 mm? recommended) with the input lead of our product through the waterproof junction box. Note the Line (-) of the lead. (see fig.5) (Junction box must be IP65 rated or above, ensure to tighten the waterproof screw)
Turn on the power to make sure the product operates normally. Adjust the irradiation angle according to the intended condition of usage. (see fig.6)

NOTE : YOU MUST COMPLY strictly to these instructions, otherwise, serious injury or death may occur.

WARNING : DO NOT tamper with the integrity of this product, it may cause harm to the user otherwise. The power of final interpretation belongs to the manutacturer.

IMPORTER : Prima Group 2004 LTD, Bulgaria, 1784 Soﬁa, Mladost 1, bl. 144, Ground Floor; Phone: +359 2 988 45 72;