VISUAL COMFORT CD 5014 Brindille Large Four Light Chandelier Instruction Manual

VISUAL COMFORT CD 5014 Brindille Large Four Light Chandelier Instruction Manual

NOTICE

This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved.

TOOLS REQUIRED (NOT INCLUDED)

• Phillips Screwdriver
• Slotted Screwdriver
• Wire Strippers
• Wire Cutters

ASSEMBLY INSTRUCTIONS

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Remove mounting plate (B) from canopy (H) by removing collar ring (I) .

3. Install mounting plate (B) to the junction box and secure with mounting screws (C) .

4. Feed electrical wires through bottom rod (K) and connect to fixture (L) . Repeat for middle rod (J), connecting to bottom rod (K) .

5. Continue feeding wires through collar ring (I), canopy (H) and top rod (G) .

6. Holding fixture upright, slide collar ring (I) and canopy (H) down and rest on fixture (L). Then connect top rod (G) to middle rod (J).
   NOTE: Slide components down slowly to avoid damages. 7. Hang fixture swivel ball (F) to center of mounting plate (B) and secure with set screw (D) using provided wrench (E) .

7. Cut excess wire, being sure to leave enough to reach the junction box. Separate wires, and strip insulation on each 5/8″.

8. Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten.
   NOTE: It is imperative that the fixture is grounded.

9. Connect driver input neutral wire (white) to the supply neutral wire (usually white) using wire nut (A)

10. Connect driver input hot wire (black) to the supply hot wire (usually black) using wire nut (A).
    CAUTION: Do not reverse the hot and neutral connections.

11. Connect fixture neutral wire (black) to driver output wire (black) using wire nut (A).

12. Connect fixture hot wire (red) to driver output wire (red) using wire nut (A).
    CAUTION: Do not reverse the hot and neutral connections.

13. Make sure all wire connections are tight, then carefully tuck into the junction box.

14. Insert driver into mounting plate (B) bracket.

15. Install canopy (H) to mounting plate (B) and secure with collar ring (I).

16. Thread glass shades (N) to light sources (M).
    NOTE: Do not over-tighten otherwise shade could become damaged.

17. Adjust light sources (M) to desired angle.
    NOTE: The light source can be rotated left or right and directed upwards or downwards.

Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.

Symbols

Documents / Resources

| VISUAL COMFORT CD 5014 Brindille Large Four Light Chandelier [pdf] Instruction Manual
CD 5014, CD 5014 Brindille Large Four Light Chandelier, Brindille Large Four Light Chandelier, Large Four Light Chandelier, Four Light Chandelier, Chandelier
---|---

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>