IQxel-M16W Multi-DUT Connectivity Test System Specifications Manual
- June 8, 2024
- LitePoint
Table of Contents
- IQxel-M16WTM
- General Technical Specifications
- Wireless LAN 802.11a/b/g/n/p/j/ah/af, 802.11ac (Wi-Fi 5), 802.11ax1 (Wi-
- 802.11ax (Wi-Fi 6) Waveform Generation
- MIMO System Performance
- Bluetooth® (1.0, 2.0, 2.1, 3.0) Measurement Specifications
- Bluetooth 5 Measurement Specifications
- ZigBee (802.15.4), Z-wave (ITU-T G.9959), Wi-SUN (MR-FSK IEEE 802.15.4g)
- DECT (ETSI EN 300 176-1)
- Navigation1
- Port Descriptions
- General and Environmental
- Order Codes
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
IQxel-M16WTM
Multi-DUT Connectivity Test System
General Technical Specifications
RF Analyzer
RF Analyzer – Signal Trigger
1 Excludes image rejection
RF Generator
Port Isolation
Timebase
Wireless LAN 802.11a/b/g/n/p/j/ah/af, 802.11ac (Wi-Fi 5), 802.11ax1 (Wi-
Fi 6) Measurement Specifications
1 802.11ax IEEE draft 1.2 support with firmware v1.7 or higher
2 Based on calibration ver 1.2.11, FW ver 1.9.1 or higher
802.11ax (Wi-Fi 6) Waveform Generation
MIMO System Performance
The additional specifications in the table below apply to the complete IQxel- M16W MIMO system.
Bluetooth® (1.0, 2.0, 2.1, 3.0) Measurement Specifications
1 IQxel-M16W supports testing sensitivity with Dirty Packets
1 NOC and EOC tests are the same except for the operating conditions which do not impact the test equipment requirements
2 External signal source required for these measurements (not LitePoint supplied)
3 IQxel-M16W provides the wanted signal only. No interfering signal is available
Bluetooth 5 Measurement Specifications
Bluetooth 5 introduced a couple of new test requirements:
Data Rate: New requirements for testing with 2 Mbps, 1 Mbps, 500 kbps, 125 kbps signal
Stable Modulation: Optional requirement for device to support smaller variation in the frequency deviation during modulation (modulation index between 0.495-0.505). This enhancement gives device stable and better range coverage and thus competitive advantage
IQxel-MW is capable of testing for these new requirements
ZigBee (802.15.4), Z-wave (ITU-T G.9959), Wi-SUN (MR-FSK IEEE 802.15.4g)
DECT (ETSI EN 300 176-1)
Navigation1
1 Navigation is a standard feature included with general purpose RF function
2 Require external attenuation for the power levels below -95 dBm
Port Descriptions
Front Panel
Rear Panel
General I/O
General and Environmental
1 Specifications valid over temperature range after invoking temperature compensation function.
For highest accuracy, recommend to enable temperature compensation if ambient temperature changes by more than 2°C.
Order Codes
IQxel-M16W Multi-DUT Connectivity Test System Specifications Manual –
Optimized PDF
IQxel-M16W Multi-DUT Connectivity Test System Specifications Manual –
Original PDF
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>