SPARX S11908 Fast Wireless Charging Pad User Manual
- October 30, 2023
- SPARX
Table of Contents
SPARX S11908 Fast Wireless Charging Pad
Use Steps
- Connect to Dower Adaptor
- Charge Your Phone
Instructions
- Please use the USB cable attached.
- Please make sure your device is Qi-enabled or installed with Qi receiver kit.
- A Quick Charge adapter and cable are required for the fast wireless charging feature. The original Quick Charge adapter is recommended (Except the adapter from S7 and S7 Edge).
Attentions
- Do not disassemble the device
- Please use a 5V / 2A (min) or above power adapter for standard charging.
- Fast-charging function is only available for Qi-enabled devices or devices installed with Qi receiver kit which support fast wireless charging.
- If the Qi-enabled device couldn’t send charging complete signal, LED indicator will keep on lighting.
Precautions
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>