Aerpro FP8567 Double DIN Fitting Kit User Manual
- June 12, 2024
- Aerpro
Table of Contents
FP8567
Double DIN Fitting Kit
for Isuzu/Mazda Vehicles
FP8567 Double DIN Fitting Kit
IN THE KIT
- Double DIN Fascia Panel
- Brackets
- Screws (x4)
APPLICATION
Note: Application data is subject to change at any time
Isuzu D-Max
Mazda BT-50| 2020 >
2020 >
---|---
Please Note: this installation works for vehicles with and without an OEM touch screen.
FEATURES
- Allows for the installation of a double DIN aftermarket stereo
- Includes mounting brackets and fitting accessories
- Finished in piano black to match vehicle dashboard
DISCLAIMER
The information provided in this document is subject to change without notice
due to manufacturer changes and/or improvements to the product/s. This
instruction manual is based on documented data and research. The manufacturer
of this product cannot be held responsible for any changes made to the vehicle
by the manufacturer or damages that may occur through the installation of this
product in accordance with the steps outlined herein.
PRIOR TO INSTALLATION
Read the manual prior to installation. Technical knowledge is necessary for installation. The place of installation must be free of moisture and away from heat sources. Please ensure that the correct tools are used during the installation to avoid damage to the vehicle or product. Aerpro can not be held responsible for the installation of this product.
INSTALLATION GUIDE
DASH DISASSEMBLY
It is worth noting that this double DIN fascia kit will work with both OEM
single DIN and touch screen system layouts.
In both cases, begin the installation by using a panel removal tool to
disengage the clips that hold the main fascia panel in place. This panel also
includes the side vents. Once out, remove all connections between either the
single DIN radio or touch screen monitor.
With the main fascia panel out of the way, undo the following four screws and
put these to one side. With the screws out, fully remove the metal bracket.
Note: touch screen models will have the main head unit housed here.
Simply disconnect the wiring and follow the guidance above.
Undo all four screws located on the rear of the main fascia panel. These screws will disengage the air vents and trim from the main single DIN unit/touch screen.
Position the new fascia panel in front of the main air vent/trim panel and screw into place using the screws provided in this kit.
BRACKET ASSEMBLY
Take the brackets found within the kit and offer them up to the relevant side of the new radio. Once positioned correctly, screw them into place using a set of radio screws (not supplied with this kit).
DASH ASSEMBLY
With the brackets attached and the connections made to the rear of the radio, place the unit into the dashboard and screw into place using the four pre- exisiting screws removed in earlier (see Step 2).
Place the new fascia panel over the front of the new radio to complete the
installation.
Note: if the radio sits too far forward/back, repeat the process from
Step 5 and adjust the depth of the radio accordingly.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>