smappee EV Wall Home EV Charger Installation Guide
- June 12, 2024
- smappee
Table of Contents
smappee EV Wall Home EV Charger
Product Information
The EV Wall HOME is a three-phase electric vehicle charging station designed for home and workplace use. It comes with various components including the EV Wall housing, mounting plate, power supply cable, communication cable, charging cable, CT Hub, Current Transformers (CTs), and Smart Charge Card. The EV Wall HOME is compatible with the Smappee App, which allows for easy configuration and monitoring of the charging station.
What’s in the box?
Optional: 8 m cable with cable holder
Three phase Connection diagram
- Socket version
- Fixed cable version
Connect the CT to measure solar to the correct phase. Adjust the configuration in the Smappee App when this is not the L1 phase. When the solar installation is 3-phased, you need to purchase and install the EV Wall solar add-on. In case of 3-phase delta (3*230 V) or shutter version, consult the full manual via the QR code: Manual
Safety warning
Carrying out electrical work within the home or workplace can be dangerous and must be conducted according to the appropriate national safety standards and executed by a certified electrician. For safety purposes, it is also necessary to power off the installation before proceeding with the physical installation.
For further safety instructions and more detailed information, please consult the full manual at smappee.com/downloads or via the QR code:
Product Usage Instructions
- Prepare the installation by ensuring there is a power supply and communication cable between the EV Wall and the distribution panel. Note that the power supply cable must be protected by the appropriate circuit breaker and RCD where required.
- Fix the mounting plate to the wall using the provided plugs andscrews.
- Attach the EV Wall housing to the EV Wall mounting plate using the provided small screws.
- Connect the power supply cable, communication cable, and charging cable (if applicable) to the EV Wall. Connect the cables to the cover’s PCB. Then attach the front panel to the EV Wall and btighten the M4 nuts to close it. Refer to the diagrams provided for reference. If you have a 3-phase delta or shutter version, consult the full manual online for specific instructions.
- Install the EV Wall modules as indicated in the diagram provided. The Connect, Splitter, CT Hub, and Current Transformers (CTs) are installed inside the distribution panel. These components communicate with the charging station via the CAT 5/6 communication cable.
- Switch on the power using the circuit breaker.
- Download the Smappee App and follow the instructions to configure your Smappee charging station.
- Once the Smappee Connect shows a green pulsing light, validate the installation by verifying that the real-time bubbles show correctly measured values in the Smappee App/Dashboard.
- Use the Smappee app to send an invite to your customer’s email address to share the newly created location with them. This useraccount will be used for the Smappee App and Dashboard and to set smart charging preferences. Finally, hand over the Quick Starter Guide for further assistance.
For additional safety instructions and more detailed information, please consult the full manual available at smappee.com/downloads or scan the QR code provided.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>