energenie SPG5-C-5 Surge Protector User Manual
- June 6, 2024
- energenie
Table of Contents
SPG5-C-5, SPG5-C-10,
SPG5-C-15
SURGE PROTECTOR, 5
SOCKETS, 1.5/3/4.5M
www.energenie.com
Pure Power
Connection
Connect the electrical plug of the SPG5-C-xx filter to the power source. Then connect consumers (no more than five ) to the sockets of the device. Turn on the filter.
Self-diagnosis
Red illumination of the switch in the “ON” (“I” ) position means that the
device is turned on.
When the green LED “GROUNDED” is on, a good ground circuit exists.
When the red LED “PROTECTED” lights up, the protective circuit is OK.
Safety information
The device is intended for indoor use only. Do not allow moisture and dirt to
get on the device.
It is forbidden to connect two or more main filters in series.
Do not cover the device during operation.
After disconnecting the filter plug from the supply
voltage, no residual potential remains in the device.
Declaration of conformity
This product is tested and complies with the essential requirements of the
laws of member states concerning LVD (2014/35/EU ), EMC (2014/30 / EU ), ROHS
(2011/65 / EU ). The CE declaration can be found under
www.gembird.eu
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>