smappee EV One Home Floor-Mounted Smart EV Charging Station User Guide

smappee EV One Home Floor-Mounted Smart EV Charging Station

What’s in the box?

Three phase Connection diagram

Safety warning

Carrying out electrical work within the home or workplace can be dangerous and must be conducted according to the appropriate national safety standards and executed by a certified electrician.
For safety purposes, it is also necessary to power off the installation before proceeding with the physical installation.

For further safety instructions and more detailed information, please consult the full manual at smappee.com/downloads or via the QR code:

How to install EV One HOME

1. Prepare the installation. Foresee a power supply & communication cable between the EV One and the distribution panel. Dig a hole for the anchor and ensure the bottom is flat and stable.

2. Take the EV One out of its packaging. Unscrew the two bottom screws and slide the outer housing upwards, off the internal structure. Take the anchor out and assemble the anchor onto the main unit as shown in the diagrams.
   If desired, the top half of the EV One can be temporarily removed and set aside.

3. Place the anchor in the ground. Route the power supply and communication cable through the anchor and into the EV One. Make sure it is level and the bottom of the EV
   One will be flush with the ground level. Fill the hole with concrete.

4. Connect the power supply cable according to the connection diagram. Connect the CAT 5/6 communication cable to the ‘A+B’ port.
   In case of 3-phase delta (3*230 V), please consult the full manual online.

5. Connect the EV One modules as indicated in the diagram.
   The Connect, the Splitter, the CT Hub and CTs are installed inside the distribution panel. These components communicate with the charging station via the CAT 5/6 communication cable.

6. Switch on the power using the circuit breaker.

7. Download the Smappee App and follow the instructions to configure your Smappee charging station.

8. Once Smappee Connect shows a green pulsing light, validate the installation by verifying that the real-time bubbles show correctly measured values in the Smappee App/Dashboard.

9. Slide the housing onto the EV One and tighten the screws. Attach the door.

10. Use the Smappee app to send an invite to your customer’s email address to share the newly created location with them. This user account will be used for the Smappee App and Dashboard and to set smart charging preferences. Lastly, hand over the Quick Starter Guide.

References

• Downloads - Smappee

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>