UBIQUITI UAP-AC-Pro Access Point Installation Guide
- June 12, 2024
- UBIQUITI
Table of Contents
UBIQUITI UAP-AC-Pro Access Point
Product Information
- Installation Guide
- Radiation Exposure Statement – This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. – This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- Operating Frequency (MHz):
- 2400-2483.5 MHz with a maximum RF output power of 20 dBm
- 5150-5350 MHz with a maximum RF output power of 23 dBm
- 5470-5725 MHz with a maximum RF output power of 30 dBm
- This device is restricted to indoor use only when operating in the 5150 – 5350 MHz frequency range within all member states. Operation in the 5.8 GHz frequency band is prohibited in non-BFWA (Broadband Fixed Wireless Access) member states.
- Declaration of Conformity: UBIQUITI declares that this device, UAP-AC-Pro, is in compliance with the essential requirements and other relevant provisions of Directives 2014/53/EU, 2014/30/EU, 2014/35/EU. The device has software that cannot affect the conformity with the Radio Equipment Directive (RED), even if the software is changed or replaced. The full text of the EU declaration of conformity and detailed compliance information is available at the following internet address: ui.com/compliance
- Manufacturer: Ubiquiti International Holding B.V.
- Address: Ekkersrijt 3102, Son, Netherlands
Product Usage Instructions
- Ensure that the equipment is installed and operated with a minimum distance of 20 cm between the radiator and your body.
- Do not place or operate this transmitter in conjunction with any other antenna or transmitter.
- Operating Frequency and RF Output Power:
- For frequencies between 2400-2483.5 MHz, the maximum RF output power is 20 dBm.
- For frequencies between 5150-5350 MHz, the maximum RF output power is 23 dBm.
- For frequencies between 5470-5725 MHz, the maximum RF output power is 30 dBm.
- This device is only intended for indoor use when operating in the 5150 – 5350 MHz frequency range within all member states. Do not use this device in non-BFWA member states where operation in the 5.8 GHz frequency band is prohibited.
- To ensure compliance with regulations, refer to the full text of the EU declaration of conformity and detailed compliance information available at ui.com/compliance.
Safety Notices
(if applicable)
- Read, follow, and keep these instructions.
- Heed all warnings.
- Only use attachments/accessories specied by the manufacturer.
WARNING : Failure to provide proper ventilation may cause a hazard. Keep at least 20 mm of clearance next to the ventilation holes for adequate air‹ow.
WARNING: To reduce the risk of are or electric shock, do not expose this product to rain or moisture.
WARNING: Do not use this product in a location that can be submerged by water.
WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.
Electrical Safety Information
(if applicable)
- Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power source than those specied may result in improper operation, damage to the equipment, or pose a re-hazard if the limitations are not followed.
- There are no operator-serviceable parts inside this equipment. Service should be provided only by a qualified service technician.
- This equipment is provided with a detachable power cord which has an integral safety ground wire intended for connection to a grounded safety outlet.
a. Do not substitute the power cord with one that is not the provided approved type. Never use an adapter plug to connect to a 2-wire outlet as this will defeat the continuity of the grounding wire.
b. The equipment requires the use of the ground wire as a part of the safety certification, modification or misuse can provide a shock hazard that can result in serious injury or death.
c. Contact a qualified electrician or the manufacturer if there are questions about the installation prior to connecting the equipment.
d. Protective earthing is provided by a Listed AC adapter. Building installation shall provide appropriate short-circuit backup protection.
e. Protective bonding must be installed in accordance with local national wiring rules and regulations.
Radiation Exposure Statement
- This equipment should be installed and operated with a minimum distance 20 cm between the radiator and your body.
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device is restricted to indoor use only when operating in the 5150 – 5350 MHz frequency range within all member states. Operation in the 5.8 GHz frequency band is prohibited in non-BFWA member states.
Declaration of Conformity
Hereby, UBIQUITI, declares that this device, UAP-AC-Pro, is in compliance with
the essential requirements and other relevant provisions of Directives
2014/53/EU, 2014/30/EU, 2014/35/EU. The device has software that cannot affect
conformity with the RED, even if the software is changed or replaced. The full
text of the EU Declaration of conformity and detailed compliance information
is available at the following internet address: ui.com/compliance
Ubiquiti International Holding B.V.
Ekkersrijt 3102, Son, Netherlands
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>