UBIQUITI 6545A-U6P 300mbps BGN Access Point Instruction Manual
- October 30, 2023
- UBIQUITI
Table of Contents
E-Label User Information
FCC ID: SWX-U6P
IC ID: 6545A-U6P
Ubiquiti Inc. will be incorporating the E-Label procedures per FCC KDB
784748-D02. The information below is what will be included in the E-Labeling.
E-label and warning statements can be found in the device/controller GUI under
Device > Settings > About.
Detailed compliance information including Declaration of Conformity is
available at the following internet address:
ui.com/compliance
FCC
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions.
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generated, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operations of this equipment in a residential area is likely to cause harmful interference in which case the user bill be required to correct the interference at his own expense.
ISED Canada
CAN ICES-3 (A) / NMB-3 (A)
This device complies with ISED Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
CAN ICES-3 (A) / NMB-3 (A)
- I’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
RF Exposure Warning
The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be located or operating in conjunction with any other antenna or transmitter.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>